Allied Telesis AT-2916SX, AT-2972SX Modifying a Team, From the Tools menu, click Configure a Team

Advanced Control Suite User’s Guide

Modifying a Team

Note

When you create Generic Trunking and Link Aggregation teams, you cannot designate a Standby Member. Standby members work only with Smart Load Balance and Failover and SLB (Auto-Fallback Disable) types of teams.

Note

For an SLB (Auto-Fallback Disable) team, when you want to restore traffic to the load balance members from the standby member, click the Fallback button on the Team Properties Tab.

Note

Not all network devices made by other vendors are supported or fully certified for teaming.

9.Configure the Team IP address if necessary by choosing Start > Settings > the team name > Properties.

If other network devices in your computer use TCP/IP bindings, the TCP/IP Properties windows is displayed.

10.Configure the IP address and any other necessary TCP/IP configuration for the team and click OK when finished.

After you have created a team, you can modify the team in the following ways:

ˆChange the type of team

ˆChange the members assigned to the team

ˆAdd a VLAN

ˆRemove a team or a VLAN

To modify a team, perform the following procedure.

1.Select the team name.

2.From the Tools menu, click Configure a Team.

The Welcome page of the Broadcom Teaming Wizard is shown in Figure 11 on page 44.

3.Click Next.

The Team Name page asks for a name for the team, as shown in Figure 12 on page 44.

4.Type the name of the team you want to modify and click Next.

57