Hughes Installation | Configuration and Connections |
|
|
|
|
Hughes-JVC DILA Projector Configuration (RS-232)
Verify that the System 8/10 Plus is already configured for the
1.Use a small screwdriver to remove the access cover from the System 8/10 Plus front panel. Refer to page
_______________ Before changing anything, remove the AC power cord to the System 8/10 Plus
and also turn the projector’s power OFF.
2. Set the System 8/10 Plus switches as follows:
Config | Model | Rotary Switches | Cable |
|
| SW15 Settings |
|
| Comm | ||||||||
as |
| RS1 | RS2 | RS3 | RS4 | J2/J3 | 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 | 10 | Adapter |
|
| 0 | 0 | F | 8 | J2 | ↓ | ↓ | − | ↓ | − | ↓ | ↓ | ↓ | − | ↓ |
|
ON
1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 | 10 |
RS2 |
RS1 |
RS5 RS2 RS1
Configured For:
SW15 DIP Switch
RS3 RS4
RS3 |
RS4 |
3.Locate the switcher’s Address DIP switches on the rear panel, lower right. Unless this is part of a master/slave system, set #3 and #5 to the up position and the others in the down position. See illustration on the left.
4.Use the illustration on the following page and continue with the steps below.
5.Connect the BNC cables from the System 8/10 Plus outputs to the projector inputs according to the application requirements (RGBS,
6.Apply Main Power to the System 8/10 Plus by connecting the power cord. The Main Power LED should light. Apply power to the projector.
7.Installation is now completed.
Extron • System 8/10 PLUS • User’s Manual • P/N | Page 1 |