Hughes Installation | Configuration and Connections |
|
|
|
|
Special Instructions for the HJT Model 100/200 Series |
|
The projector documentation provides instructions on how to set up and configure the Model 100/200 Series Projector for proper operation with the System 8/10 PLUS.
The baud rate for the Extron switchers is 19200. Since Port A is locked to a baud rate of 9600, Port B should be used for Extron Switchers. The projector port assignment must be selected and the VIC channel assignment must be edited for a switcher. Following is a description of the HJT 100/200 Series Menu.
To select the Baud Rate from the Projector:
1.Go to Main Menu, select #7, System, then #4, Comm. Setup.
2.From the Comm. Setup menu, select Port B Speed.
3.From the Speed selection list, select 19200.
4.Press Escape to go back to the Comm. Setup level.
To set the projector port assignment from the Projector:
1.From the Comm. Setup menu, select Port B Device.
2.From the Device type list, select #3, Video Switcher.
3.Turn power off at the remote control.
4.Wait until the Arc Lamp fans have stopped running and provide a system cold boot by toggling the circuit breaker on the projector rear panel to Off, then back to On.
To edit the VIC channel assignment from the Projector:
(see the Model 100/200 User’s Guide, Section 5.3.1 for more information on editing):
1.From the Channels list, select the channel that the switcher will be assigned
to.
2.Press Mode. This is a toggle key that brings up a submenu for editing. (Press Mode again to remove the submenu.)
3.Select Edit from the submenu and press Enter.
4.Use the right arrow key to toggle over to the third VIC column.
5.Press Enter and use the up/down arrow keys to select the current switcher channel number. Press Enter when the current switcher channel number is shown.
6.Press Escape to exit the Edit mode.
Extron • System 8/10 PLUS • User’s Manual • P/N | Page 6 |
