Hughes Installation | Configuration and Connections |
|
|
|
|
Hughes/JVC Projector Configuration
Check to see if the System 8/10 PLUS is already configured for the Hughes/JVC projector. The general setup is explained on page
1. Use a small screwdriver to remove the access cover from the System 8/10 PLUS front panel. See bottom of page
__________ Before changing anything, remove the AC power cord to the System 8/10 PLUS
to verify that the main power is OFF; also turn the projector power OFF.
2. Set the switches as follows:
Config | Model | Rotary Switches | Cable |
|
| SW15 Settings |
|
| Comm | ||||||||
as |
| RS1 | RS2 | RS3 | RS4 | J2/J3 | 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 | 10 | Adapter |
|
| 0 | 0 | 6 | 5 | J2 | ↓ | ↓ | − | ↓ | − | ↓ | ↓ | ↓ | − | ↓ |
ON | 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 | 10 |
_ RS5 is for RGB switching delay. See page
RS2
RS5 RS2 RS1
RS1 |
SW15 DIP Switch
RS3 RS4
RS3 |
RS4 |
Configured For:
3.Use a grease pencil (or other
4.Locate the switcher’s Address DIP switches on the rear panel, lower right. Unless this is part of a master/slave system, set #3 and #5 to the up position and the others down. See picture to the left.
Use the illustration on the facing page to do the following steps.
5.Connect the Comm Adapter’s
6.Connect the
______ Secure the screws on all D connectors.
7.Connect the BNC (RGBS) cables from the System 8/10 PLUS outputs to the Hughes/JVC projector inputs according to the application requirements. (RGBS,
8.Apply Main Power to the System 8/10 PLUS by connecting the power cord. The Main Power LED should light. Apply power to the projector.
9.Return System 8/10 PLUS and projector to normal operation.
Extron • System 8/10 PLUS • User’s Manual • P/N | Page 3 |