Allied Telesis AT2972SX/2, AT-2916SX, AT-2972SX manual Advanced Control Suite User’s Guide

Advanced Control Suite User’s Guide

Note

Disabled adapters are not recognized and they prevent the creation of a VLAN. If you attempt to create a VLAN with a disabled adapter, an error message is displayed.

To configure a team with a VLAN, perform the following procedure.

Note

To maintain optimum adapter performance, your system must have 64 MB of system memory for each of the 8 VLANs created per adapter.

1.Select the team name.

The Team Properties tab opens as shown in Figure 25 on page 53.

2.In the list of adapters in the team shown on the left, right-click the name of the team you want to modify and click Add VLAN.

The Add VLAN dialog box opens, as shown inFigure 30

Figure 30. Add VLAN Dialog Box

3.Type the VLAN ID and VLAN name, then click OK.

The Untagged VLAN check box is exclusively used by the VLAN ID field. To use VLAN ID 0, simply click this check box. If you type a VLAN name or ID and the name already exists, an Input Error message appears.

4.When you are finished adding VLANs to this team, click OK. A new virtual adapter is created for each VLAN.

59