Allied Telesis AT-WCP200G manual

If the SSID parameter is “ANY,” it will detect the strongest signal of the wireless station.

❑Channel

It shows radio channel numbers that are used for Wireless LAN networking.

The channel number can be set only under the Ad-Hoc operation mode. In Ad-Hoc mode, each station must have the same channel numbers and SSID.

In Infrastructure mode, the AT-WCP200G adapter will automatically detect the channel number of the access point.

Under Security you can set:

❑Network Encryption

This function is used to protect wireless communication from eavesdropping. A secondary function of encryption is to prevent unauthorized access to a wireless network, and it can be achieved by using the Encryption function.

Check the Enable Encryption box to activate the security of the PCI Adapter.

❑Key 1 - 4:

You can type the key that you want to use from Key 1 to Key 4. The key that you type will be the encryption between the station that you are connected with.

If you select 64-bit in Hex format, you must type 10 values in the following range (0 - F, hexadecimal), or 64-bit in ASCII format, you must type 5 values in the following range (0 - 9, A - Z, and a - z Alphanumeric).

If you select 128-bit in Hex format, you must type 26 values (0 - F, hexadecimal), or 128-bit in ASCII format, you must type 13 values in the following range (0 - 9, A - Z and a - z Alphanumeric).

If you select 256-bit in Hex format, you must type 58 values (0 - F, hexadecimal), or 256-bit in ASCII format, you must type 29 values in the following range (0 - 9, A - Z and a - z Alphanumeric).

Be sure that the PCI Adapter and the wireless station is set in the same key.

❑Create with Passphrase

The Passphrase helps you create a group of WEP key in the Key Setting. If you input a phrase in the Create with Passphrase field, the group of key setting will be changed.

30