Allied Telesis AT-WCP200G manual Configuration Tab

Page 29

AT-WCP200G User’s Guide

Configuration Tab

The Configuration tab allows you to configure Network and Security.

Under Network you can configure:

❑Network Mode

Set Network Mode to “Infrastructure” when connecting to an access point or set to “Ad-Hoc” if you have several stations and want to set them as local network.

❑Network SSID

The SSID differentiates one Wireless LAN group name from another. All access points and all devices attempting to connect to a specific Wireless LAN group name must use the same SSID. A device will not be permitted to join the BSS unless it can provide the unique SSID.

29

Image 29

Contents User’s Guide Page Statement Wireless LAN Health Authorization For UseRegulatory Information Disclaimers Interference Statement Export restrictions FCC Radio Frequency Exposure StatementCE Mark Warning Protection Requirements for Health and Safety Article 3.1aPage Table of Contents Page Preface How This Guide is Organized Document Conventions Where to Find Related Guides Contacting Allied Telesyn Page Introduction Allied Telesyn AT-WCP200G PCI AdapterUnpacking and Setup Checking the Installation Hardware InstallationDriver For Windows 98/ME/2000/XP Software InstallationInstalling AT-WCP200G User’s Guide Select Anyway AT-WCP200G User’s Guide Utility For Windows 98/ME/2000/XP Wireless LANAT-WCP200G User’s Guide Page AT-WCP200G User’s Guide Page Wireless Utility Setting Status Tab Configuration Tab Page Advanced Tab Page Profile Tab Network Tab Statistic Tab About Tab General Technical SpecificationsOperating 0o~ 40o C, Storage -25o~ 70o C Regulatory Domains