source is working and there is still no sound, see Cause 2.
Cause 2: The card output is turned OFF.
Solution 1: Turn ON the card output that is used. See
Solution 2: If there | is still no | sound, | see |
Cause 3. |
|
|
|
Cause 3: Cable | connections | to | the |
destination are incorrect.
Solution: Make sure that cables are connected properly. Also, make sure that the continuity and wiring are good. If there is still no sound present, see Cause 4.
Cause 4: The destination amplifier has a problem.
Solution 1: Make sure that the destination amplifier is powered. If there is still no sound, see Solution 2
Solution 2: Set the volume of the destination amplifier to a reasonable level. If there is still no sound, call ALTINEX at (714)
8.3 SOUND DISTORTION
Cause 1: The source level is above 1V
Solution: Make sure that the source level is below 1V
Cause 2: The destination amplifier provides excessive amplification.
Solution 1: Make sure that the source level is high enough so the destination amp does not have to provide excessive amplification thereby distorting the signal. If there is still sound distortion, see Solution 2.
Solution 2: Call ALTINEX at (714)
8.4 SOUND LEVEL IS LOW |
|
| |
Cause 1: The | volume | levels | are |
inappropriate. |
|
| |
Solution 1: Turn up the source volume. If sound level is still low, see Solution 2.
Solution 2: Turn up the destination amplifier volume. If the sound level is still low, see Cause 2.
Cause 2: Poor signal transmission.
Solution: Check the cables for continuity and make sure that connections are wired properly to verify that there is good signal transmission.
NOTE: Test the system by removing the
ALTINEX POLICY | 9 |
9.1 LIMITED WARRANTY / RETURN POLICY
Please see the Altinex website at www.altinex.com for details on warranty and return policy.
9.2CONTACT INFORMATION ALTINEX, INC
592 Apollo street
Brea, CA 92821 USA
TEL: 714
TOLL FREE:
WEB: www.altinex.com
10