Altinex MT108-105 Precautions / Safety Warnings, General, Installation, Cleaning, FCC / CE Notice

Page 3

MULTI-TASKER

PRECAUTIONS / SAFETY WARNINGS

1

Please read this manual carefully before using your MT108-104/(105)Line Driver. Keep this manual handy for future reference. These safety instructions are to ensure the long life of your MT108-104/(105)and to prevent fire and shock hazard. Please read them carefully and heed all warnings.

1.1 GENERAL

Qualified ALTINEX service personnel, or their authorized representatives must perform all service.

1.2 INSTALLATION

To prevent fire or shock, do not expose this unit to rain or moisture. Do not place the MT108-104/(105)in direct sunlight, near heaters or heat radiating appliances, or near any liquid. Exposure to direct sunlight, smoke, or steam can harm internal components.

Handle the MT108-104/(105)carefully. Dropping or jarring can damage the card.

Do not pull the cables that are attached to the MT108-104/(105).

Insert the card carefully into the slots of the Multi-Tasker™ without bending any edges.

When removing a card, please make sure that the expansion card to which it is attached is also pulled out simultaneously.

1.3 CLEANING

Clean only the connector area with a dry cloth. Never use strong detergents or solvents, such as alcohol or thinner. Do not use a wet cloth or water to clean the card. Do not clean or touch any component or PCB.

1.4 FCC / CE NOTICE

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including

interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.

Any changes or modifications to the unit not expressly approved by ALTINEX, Inc. could void the user’s authority to operate the equipment.

2

Image 3
Contents MT108-104/MT108-105 Table of Contents General Precautions / Safety WarningsInstallation CleaningTechnical Specifications MT108-104/105Mechanical Application Application DiagramApplication Diagram 2 Internal View of the MT108-104/105 Installing Your MT108-104/105 Description of CommandsOperation + or CiSCLRCnUi SELVOL CLR CardLED is not LIT Troubleshooting GuideSummary of Commands 11. RDSound Level is LOW Altinex PolicyCause 3 Cable Sound Distortion