INSTALLING YOUR | 6 |
Step 1. Turn OFF the power to the
Step 2. Slide the
Step 3. Turn ON the power to the
Step 4. The LED on the card panel will turn RED indicating that the card is in full operation.
Step 5. Connect a VGA cable from the video source to the
Step 6. The power LED will turn GREEN, indicating an input signal is present.
Step 7. Connect the
OPERATION | 7 |
There is only one adjustment necessary to operate the
The unit will operate successfully as long as cables are attached properly and other technical specifications are followed.
TROUBLESHOOTING GUIDE | 8 |
We have carefully tested and have found no problems in the supplied
7.1 LED IS NOT LIT
Cause 1: Card cage is not plugged in.
Solution: Plug in the card cage. If the LED turns ON, the problem is solved. If not, see Cause 2.
Cause 2: Card is not plugged in all the way.
Solution: Push the card in all the way. If the LED is still not lit, see Cause 3.
Cause 3: Card cage slot has a problem.
Solution 1: Test the card in other slots. If other slots work, the problem is the card cage slot. The card cage may require service. Call ALTINEX at
(714)
Solution 2: Take any other known good card with an LED and verify that the slot used is good by seeing if the other card’s LED lights in that slot. If it lights, then the original card may be the source of the problem. Call ALTINEX at (714)
7.2 NO DISPLAY
Cause 1: The source has a problem.
Solution: Check the source and make sure that there is a signal present and all source connections are correct. If the source is working and there is still no display, see Cause 2.
Cause 2: Cable connections are incorrect.
Solution: Make sure the cables are connected properly. Also, make sure the continuity and wiring are good. If there is still no display, see Cause 3.
Cause 3: The display has a problem.
Solution: Make sure that the display is powered. If there is still no display, call ALTINEX at (714)
6 |