Restore Channels/Talkgroups to the Scan List
Power off the radio then turn it on. – OR – Press the preprogrammed Scan button to stop the scan. The deleted nuisance channels/talkgroups are restored to the scan list.
–OR – Select a channel/talkgroup that has not been preprogrammed for scan by your dealer/programmer. Once you return to the original channel/talkgroup, the deleted nuisance channels/talkgroups are restored to the scan list.
LED Indicators
LED State/Color | Indication |
|
|
Radio Call |
|
|
|
Red | Transmitting |
|
|
Flashing Red | Receiving |
|
|
Flashing Red | Channel/Talkgroup Busy |
|
|
Scan |
|
|
|
Flashing Green | Scanning for activity |
|
|
Call Alert |
|
|
|
Flashing Yellow | Indicates receiving a Call Alert |
|
|
Selective Call |
|
|
|
Flashing Yellow | Indicates receiving a Selective Call |
|
|
Sticky Monitor/Open Squelch | |
|
|
Yellow | While monitoring |
|
|
Audio Indicators for Programmable Buttons
| Positive | Negative |
Programmable Buttons | Indicator Tone | Indicator Tone |
|
|
|
Scan | Start | Stop |
|
|
|
Power Level | High | Low |
|
|
|
Squelch | Tight | Normal |
|
|
|
Repeater/Talkaround | Does not use | Uses repeater |
repeater |
| |
|
| |
|
|
|
VOX | Enabled | Disabled |
|
|
|
Silent Monitor/Open Squelch | – | Enabled |
|
|
|
Option Board | Enabled | Disabled |
|
|
|
Escalert | Enabled | Disabled |
|
|
|
You can check battery charge status if your dealer has preprogrammed one of the programmable buttons. Hold down the preprogrammed Bat- tery Indicator button. The charge status is shown on the display.
Battery Level | LED Indicator |
|
|
Good | Green |
|
|
Sufficient | Yellow |
|
|
Low | Flashing Red |
|
|
Very Low | None |
|
|