Installing the PCI
4.Remove the selected expansion slotÕs backplate by removing the mounting screw and lifting out the backplate.
5.Attach a grounding strap to your wrist or ankle, and carefully remove the adapter from its antistatic bag.
PCB Jumpers
Additional Connector
on Adapter Board
2
Figure 2-3. Single-ended PCI Adapter
6.Set the jumpers on the PCI Adapter as described in Table
Terminators - The SCSI bus (cable) must be properly terminated at each end of the bus. The first and last device on the bus should be the only devices that are set to provide this function.
Terminator Power - The SCSI terminators require adequate voltage to properly terminate the cable. All SCSI host adapters on the bus should be set to supply terminator power; and where possible, be located at the end of the bus and serve as cable terminators.