Motorola MPMC101 user manual Windows NT Operating Systems, Windows NT Setup

Page 36

3

Software Driver Installation

Windows NT Operating Systems

The remainder of this chapter describes the procedure for installing the software driver within the Windows NT 3.51 operating system for the PCI and PMC Adapters. They can be installed as part of the Custom setup procedure or from within the Windows NT environment. For additional instructions on installing and configuring SCSI adapters with this operating system refer to the Microsoft Windows NT System Guide.

Before installing the Windows NT Driver, verify your system meets the following minimum requirements:

❏A Power PC system running Microsoft Windows NT 3.51 or later.

❏16MB total system memory.

Installing the Windows NT Driver

The PCI and PMC Adapters use the NCR 53C825 SCSI controller. Drivers for this controller are already included in the Microsoft Windows NT version 3. 51 operating system.

To install the PCI and PMC Adapters hardware driver:

1.Click on the Windows NT Setup icon from the Main group to display the dialog shown in Figure 3-1.

Figure 3-1. Windows NT Setup

3-2

Image 36

Contents MPMC101 PMC SCSI-2 Adapter User’s ManualRestricted Rights Legend Preface Related Documentation Acronyms and Terminology Conventions Safety Summary Safety Depends On You Page Contents List of Figures List of Tables Xii Adapter Overview PCI SCSI-2 AdapterProduct Features Supported Software Drivers System RequirementsPCI Overview Introduction to SCSI-2 Single Initiator, Single Target SystemsTarget with Multiple Peripherals Multiple Device Conﬁguration Introduction Overview Tools RequiredUnpacking the Adapter Installing the PCI SCSI-2 Adapter Desktop PCI Slot Conﬁguration Single-ended PCI Adapter PCI SCSI-2 Adapter Jumper Settings Jumper SettingInserting the PCI Adapter Card Adapter Card Installed to Chassis Installing the PMC SCSI-2 Adapter Differential PMC SCSI-2 AdapterInstalling the PMC Adapter Installing the PMC SCSI-2 Adapter PMC SCSI-2 Adapter Jumper Settings JA4 Connecting to the Scsi Bus Connector and Cable Requirements Single-ended Differential10. Scsi Connector Port Software Driver Installation AIX Operating SystemsWindows NT Setup Windows NT Operating SystemsScsi Adapter Setup Setup Message Installed Adapter Listing Restart Message Start-up Problems Problem Possible Solution Computer willStart-up Boot-up Bootup ProblemsApplication Problems PCI and PMC Adapter ProblemApplications PCI and PMC AdapterUser Notes Hardware Table A-1. PCI and PMC Adapter SpeciﬁcationsSpeciÞcation Connectors and Cables Table A-3. Connector and Cable RequirementsEnvironment Table A-2. Environmental SpeciﬁcationsConnector Cable Signal Contact Conductor Name Number Scsi P Cable Contact AssignmentsTable A-4. Single-ended Contact Assignments Table A-5. Differential Contact Assignments Bus Device Reset CCB Command Control BlockAdapter Ansi American National Standards InstituteCCS Command Control Set CDB Command Descriptor BlockDMA Direct Memory Access CPU Central Processing UnitDriver EIA Electronic Industries AssociationEisa Expanded Industry Standard Architecture EncodeHost name Ieee Institute of Electrical and Electronic EngineersInitiator InteroperabilityLocal Local busLog LU Logical UnitPropagation delay RAM Random Access MemoryPCI Peripheral Component Interconnect Point-to-pointSingle-ended Single-threadedSynchronous transmission TargetPage Index PCI IN-11