Motorola MPMC101 CCS Command Control Set, CDB Command Descriptor Block, Decode, Differential

Page 50

G

L

O

S S A R Y

Glossary

CCITT

International Telephone and Telegraph Consultative Committee. The international standards body for telecommunications.

CCS (Command Control Set)

A standard set of SCSI commands used to communicate with SCSI devices.

CDB (Command Descriptor Block)

A block of communication passed from the SCSI host to the SCSI target that provides all control information the target needs to carry out a command.

CPU (Central Processing Unit)

A personal computer’s main microprocessor chip.

decode

The act of recovering the original information from an encoded signal.

differential

Refers to the electrical configuration of the signals used on the SCSI bus. A set of two conductors are used to maintain a positive (+) and a negative (-) polarity. This technique allows SCSI devices to communicate over longer distances with minimum interference.

disconnect

The function used by a SCSI target to remove itself from the SCSI bus and release the control of the bus to other users.

DMA (Direct Memory Access)

A fast method of moving data between two processor subsystems without processor intervention.

GL-2

Image 50
Contents MPMC101 PMC SCSI-2 Adapter User’s ManualRestricted Rights Legend Preface Related Documentation Acronyms and Terminology Conventions Safety Summary Safety Depends On You Page Contents List of Figures List of Tables Xii Adapter Overview PCI SCSI-2 AdapterProduct Features Supported Software Drivers System RequirementsPCI Overview Introduction to SCSI-2 Single Initiator, Single Target SystemsTarget with Multiple Peripherals Multiple Device Configuration Introduction Overview Tools RequiredUnpacking the Adapter Installing the PCI SCSI-2 Adapter Desktop PCI Slot Configuration Single-ended PCI Adapter PCI SCSI-2 Adapter Jumper Settings Jumper SettingInserting the PCI Adapter Card Adapter Card Installed to Chassis Installing the PMC SCSI-2 Adapter Differential PMC SCSI-2 AdapterInstalling the PMC Adapter Installing the PMC SCSI-2 Adapter PMC SCSI-2 Adapter Jumper Settings JA4Single-ended Connecting to the Scsi BusConnector and Cable Requirements Differential10. Scsi Connector Port Software Driver Installation AIX Operating SystemsWindows NT Setup Windows NT Operating SystemsScsi Adapter Setup Setup Message Installed Adapter Listing Restart Message Start-up Start-up ProblemsProblem Possible Solution Computer will Boot-up Bootup ProblemsApplications Application ProblemsPCI and PMC Adapter Problem PCI and PMC AdapterUser Notes SpeciÞcation HardwareTable A-1. PCI and PMC Adapter Specifications Environment Connectors and CablesTable A-3. Connector and Cable Requirements Table A-2. Environmental Specifications Table A-4. Single-ended Contact Assignments Connector Cable Signal Contact Conductor Name Number Scsi P Cable Contact Assignments Table A-5. Differential Contact Assignments Adapter Bus Device ResetCCB Command Control Block Ansi American National Standards InstituteDMA Direct Memory Access CCS Command Control SetCDB Command Descriptor Block CPU Central Processing UnitEisa Expanded Industry Standard Architecture DriverEIA Electronic Industries Association EncodeInitiator Host nameIeee Institute of Electrical and Electronic Engineers InteroperabilityLog LocalLocal bus LU Logical UnitPCI Peripheral Component Interconnect Propagation delayRAM Random Access Memory Point-to-pointSynchronous transmission Single-endedSingle-threaded TargetPage Index PCI IN-11