3Com 3C510 manual Analog or Isdn Modem Connection, Self-Test Phase

Page 10

6CHAPTER 2: HARDWARE INSTALLATION

Analog or ISDN Modem Connection

To connect an analog or ISDN modem to the gateway, use a COM cable to connect the COM port of the gateway to your modem, as shown in the figure below. See your analog or ISDN modem documentation for more details.

COM

WAN

PRINT

Internet

COM

N

WA

NT

PRI

Internet

Printer

Analog or ISDN modem

Cable or DSL modem

Printer Connection To connect a printer to the gateway, connect the printer cable to the PRINT port of the gateway, as shown in the figure, above.

To use your gateway as a print server, allowing you to share one printer across your home network, see Chapter 5 of this user manual for more details.

Power To supply power to the gateway, insert the power adapter plug in the power connector of the gateway (see “Left Side Panel” on page 4). Then, power up the devices of your home network in the following order:

■Modem

■Home Ethernet Gateway

■Other devices (computers, printer, etc.)

Self-Test Phase

Once the gateway is powered up, it will automatically enter self-test phase. When it is in self-test phase, the WAN and Status LEDs (see “Top Panel” on page 4) will illuminate for about 5 seconds, and then flash three times to indicate that the self-test has finished. Finally, the Status LED will flash once per second to indicate that the gateway is operating normally.

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Home Ethernet Gateway User Guide Santa Clara, California Contents Print Server Home Ethernet Welcome to Home NetworkingGateway Kit Contents Using This GuideHardware Installation Panel LayoutTop Panel The top panel of the gateway contains 6 LEDs Left Side PanelCable or DSL Modem Connection Self-Test Phase Analog or Isdn Modem ConnectionNetwork Settings Network SettingsIf the following message appears Internet Sharing Setup Setup ProgramInternet Sharing Setup Dynamic IP Address Static IP Address PPP Over EthernetDial-up Network Choose a value from the Maximum Serial Port Speed list box Virtual ServerSetup Program Internet Sharing Setup Restore to Default Change PasswordReboot Firmware UpgradeDhcp Server DMZ HostRemote Administrator Host Print Server Configuring Printer PropertiesWindows NT Configuring onUNIX-based Platforms Print server of this product. The printer name is lpConsole Mode Glossary Glossary Index Dhcp3Com Corporation Limited Warranty Included Services Industry Canada 3COM END User Software License Agreement Product Registration
Top Page Image Contents