Adder Technology SV4, SV2 manual H2e Ee, Summary of SmartView configuration options

Page 12

In configure mode, options are entered by typing a letter followed by a number followed by (enter). Use ESC to abort the entry of an option. The SmartView will remain in configure mode until you type 'E' (enter).

For example: to set hotkey option 2 type the following at the 'C' prompt

(at SmartView 'C' prompt)

To exit configure mode type:

H2e Ee

2.6 Summary of SmartView configuration options

Full details of each of the configuration options and their uses are given in section 4. B1 - screen saver disabled (default)

B2 - Blank screen after 1 minute of inactivity

B3 - Blank screen after 2 minutes of inactivity

B4 - Blank screen after 4 minutes of inactivity

B5 - Blank screen after 8 minutes of inactivity

B6 - Blank screen after 12 minutes of inactivity

B7 - Blank screen after 16 minutes of inactivity

B7 - Blank screen after 20 minutes of inactivity

D1 - Display dot flashes to indicate activity, right handed auxiliary display (default) D2 - Display dot does not flash, right handed auxiliary display

D3 - Display dot flashes to indicate activity, left handed auxiliary display D4 - Display dot does not flash, left handed auxiliary display

D5 - Display dot flashes, auxiliary display port configured for monitor light module D6 - Display dot does not flash, auxiliary port configured for monitor light module

L1 - SmartView locks on to active ports only during autoscanning (default)

L2 - SmartView locks on to every port during autoscanning

L3 - SmartView powers on in autoscan mode and locks on to active ports only L4 - SmartView powers on in autoscan mode and locks on to all ports

L7 - SmartView cascade query code = AD (default)

L8 – SmartView cascade query code = EF

SmartView

Installation and Use

Page 11

Image 12
Contents SMARTView Safety information WarrantyAbout this manual Radio Frequency Energy European EMC directive 89/336/EECContents SmartView configuration options AppendicesKey features IntroductionPackage contents Product informationSmartView SV2 version supporting 2 PCs Installation What you will needConnecting your devices Mounting the SmartViewConfiguring your PCs Configuring the SmartViewSummary of SmartView configuration options H2e EeSmartView Installation and Use Other useful installation information Re-enabling a disconnected PS/2 mouseSmartView Installation and Use SmartView Installation and Use Using the SmartView Power on statusFront panel key and remote controller Status displayKeyboard hotkey control SmartView Installation and Use Mouse control RS232 controlCascading SmartViews SmartView Installation and Use SmartView configuration options Screen saver time delayDisplay options Autoscan lock on mode and delay time Mouse mode and mouse switching of channels Keyboard hotkey combination Firmware functions version query, mouse restore and reset Setting a security passwordExit configure mode Cascade query codeCycling between all channels or just the active channels Appendix A. Cable and connector specifications A1. Keyboard, monitor and mouse to SmartViewA2. SmartView to PCs 1 to A3. Expansion port pin assignments SmartView 4 port only Appendix B. Problem Solving Mouse causes channel to change SmartView Installation and Use SmartView Installation and Use SMARTView
Related manuals
Manual 34 pages 42.4 Kb