Adder Technology SV4 Other useful installation information, Re-enabling a disconnected PS/2 mouse

Page 14

P - Sets password - see section 4.7 for instructions.

E - Exits configure mode and returns the SmartView to normal operation mode.

2.7 Other useful installation information

PC boot up sequence - When your PCs are powered on they communicate with any attached keyboards and mice and setup parameters required by the particular operating system. It is necessary for the SmartView to be attached and powered on during this sequence so that it can give the required responses and keep track of all the modes and settings requested by each of the connected PCs.

Mouse characteristics - do not unplug a PS/2 mouse connection from a PC whilst the PC is on. Due to the design of PS/2 mice communications the mouse function on the PC will be lost and you will have to re-boot the PC to regain normal operation. Unplugging the mouse from the SmartView will also cause it to stop operating when it is plugged back in. RS232 mice can usually be unplugged and plugged back in provided that a mouse was connected when the operating system initially booted. The SmartView is fitted with a PS/2 mouse recovery system which allows you to disconnect and re-connect the shared mouse without powering down the system (although this is generally not advisable) - see section 2.8 for details.

Keyboard and mouse mode switching - The SmartView keeps a log of the keyboard and mouse mode and resolution settings requested by each of the connected PCs. These settings are automatically restored to the shared keyboard and mouse when the SmartView channel is switched thus ensuring maximum software compatibility. The keyboard num, caps and scroll lock states are an obvious example of this process.

2.8 Re-enabling a disconnected PS/2 mouse

If you disconnect the shared PS/2 mouse from the SmartView by accident during operation then the mouse operation will be lost when the mouse is plugged back in. To avoid having to reboot the entire system in this situation the SmartView is fitted with an automatic mouse recovery system.

SmartView

Installation and Use

Page 13

Image 14
Contents SMARTView About this manual Safety informationWarranty Radio Frequency Energy European EMC directive 89/336/EECContents SmartView configuration options AppendicesKey features IntroductionPackage contents Product informationSmartView SV2 version supporting 2 PCs Installation What you will needConnecting your devices Mounting the SmartViewConfiguring your PCs Configuring the SmartViewSummary of SmartView configuration options H2e EeSmartView Installation and Use Other useful installation information Re-enabling a disconnected PS/2 mouseSmartView Installation and Use SmartView Installation and Use Front panel key and remote controller Using the SmartViewPower on status Status displayKeyboard hotkey control SmartView Installation and Use Cascading SmartViews Mouse controlRS232 control SmartView Installation and Use Display options SmartView configuration optionsScreen saver time delay Autoscan lock on mode and delay time Mouse mode and mouse switching of channels Keyboard hotkey combination Firmware functions version query, mouse restore and reset Setting a security passwordCycling between all channels or just the active channels Exit configure modeCascade query code A2. SmartView to PCs 1 to Appendix A. Cable and connector specificationsA1. Keyboard, monitor and mouse to SmartView A3. Expansion port pin assignments SmartView 4 port only Appendix B. Problem Solving Mouse causes channel to change SmartView Installation and Use SmartView Installation and Use SMARTView
Related manuals
Manual 34 pages 42.4 Kb