Asus 1008P-KR-PU27-PI Powering on your Eee PC, Connect the AC power Turn on the Eee PC Adapter

Page 26

Powering on your Eee PC

These are only quick instructions for using your Eee PC.

	1. Connect the AC power	2. Turn ON the Eee PC
	adapter
	2	3
	1	3
	1

•Damage may occur if you use a different adapter to power the Eee PC.You may damage both your battery pack(s) and the Eee PC with a faulty AC-DC adapter.

•When you open the display panel, do not force it down to the table or else the hinges may break! Never lift the Eee PC by the display panel!

•Only use battery packs and power adapters supplied with this Eee PC or specifically approved by the manufacturer or retailer for use with this model or else damage may occur to the Eee PC.The output voltage of this adapter is +19Vdc, 2.1A.

•Never attempt to remove the battery pack while the Eee PC is turned ON, as this may result in the loss of working data.

Remember to fully charge the battery (8 hours or more) before first use and whenever it is depleted to prolong battery life.The battery reaches its maximum capacity after a few full charging and discharging cycles.

2-4	Chapter 2: Getting Started

Image 26

Contents Eee PC Table of Contents Support DVD & System Recovery ChapterAbout This User’s Manual Safety Precautions Transportation Precautions Airplane Precautions Charging Your BatteriesViii Chapter Top Side Touchpad Off key Built-in Camera Array Microphone Built-inDisplay Panel Powered OFF Status Indicators Battery Charge IndicatorPowered on Hard Disk Drive HDD IndicatorKeyboard Power SwitchPower Indicator Touchpad and ButtonsMemory Compartment Bottom SideVGA door Battery Pack Battery Lock ManualRight Side Left Side USB Port 2.0/1.1 Air VentsPower Indicator Rear SideKeyboard Usage Special Function KeysSuper Hybrid Engine Fn+Space Bar Toggles among Touchpad Usage Multi-finger gesture inputKnowing the Parts Getting Started Installing and uninstalling the battery pack To install the battery packTo uninstall the battery pack Powering on your Eee PC Connect the AC power Turn on the Eee PC AdapterFirst-time Startup Getting Started Desktop Configuring a wireless network connection Network ConnectionUsing a dynamic IP / PPPoE network connection Local Area NetworkClick Properties Click Internet ProtocolVersion 4TCP/IPv4 Select Broadband PPPoE and click Next Select Connect to the Internet and click NextClick Use the following IP address Using a static IPBrowsing web pages Using the Eee PC Asus Update Updating the Bios through the InternetUpdating the Bios through a Bios file To update the Bios through a Bios fileChange adapter settings Bluetooth Network DevicesClick Add a device to look for new devices Click Start All Programs Asus Eeepc SuperHybridEngine Super Hybrid EngineSuper Hybrid Engine Modes Asus @Vibe Eee DockingEee Amuse Game ParkEee Sharing Eee XperienceBoingo on selected models Eee ToolsDigital Zoom Control on selected models Function keysPress Fn + E to tilt up Microsoft Office Trial Support DVD System Recovery Boot BoosterSupport DVD information Running the support DVDContact Drivers menuUtilities menu Other informationUsing the Support DVD System RecoveryUsing Recovery Partition F9 Recovery About the Recovery PartitionRecover system to a partition Recover system to entire HDBoot Booster Bios Setup UtilityAppendixA Declarations and Safety Statements Federal Communications Commission StatementFCC Radio Frequency RF Exposure Caution Statement Eee PC 1008PIC Radiation Exposure Statement for Canada Declaration of Conformity R&TTE directive 1999/5/ECEee PC 1008P CE Marking CE marking for devices without wireless LAN/BluetoothCE marking for devices with wireless LAN/ Bluetooth Wireless Operation Channel for Different Domains France Restricted Wireless Frequency BandsUL Safety Notices Power Safety Requirement Reach NoticeNordic Lithium Cautions for lithium-ion batteries Japanese Copyright Information Copyright 2009 ASUSTeK Computer INC. All Rights ReservedService and Support Limitation of LiabilityTaiwan R.O.C