English
3.3.2 Password Recovery
The switch is protected by a password. The password is required to make CNM able to manage the switch. Once the password is lost, you need to reset the password back to factory default password, which is 0x2379. The password is four digit long, could be change through CNM.
1.Prepare one
2.Power off the switch, then power it on. Within 20 seconds after power on, plug the
3.Remain the loop about 1 minute to let the password reset happen.
4.Unplug the cable, then power cycle the switch. You can manage the switch by default password.
Note: To reset the password, there must be no connection in the switch except the loop between port 3 and 4.
3.3.3 Factory Default Setting
You can reset the switch configuration back to factory default value by the similar steps as the password recovery. Instead of looping port 3 and 4, use port 1 and 2 to make a loop.
1.Prepare one
2.Power off the switch, then power it on. Within 20 seconds after power on, plug the
3.Remain the loop about 1 minute to let the configuration reset happen.
4.Unplug the cable, then power cycle the switch. You can manage the switch by default password and the switch configuration is back to factory default.
14 | GigaX Centralized Network Management User’s Manual |