Asus GIGAX1024P warranty Enable or disable a port, Link Aggregation

Page 33

English

1.Enable or disable a port

2.Speed and duplex mode. Select 1000 full-duplex on the Fast Ethernet ports (from 1 to 24) will set the ports to 100 full-duplex mode.

3.Flow control - Back pressure flow control is used in half and full duplex modes to prevent packet loss.

A software reset will be triggered after the configuration is apply. The purpose of software reset is to restart link negotiations.

4.7.2 Link Aggregation

Figure 4.19. Link Aggregation

32	GigaX Centralized Network Management User’s Manual

Image 33

Contents Copyright Information Centralized Network Management Table of Contents Introduction GigaX 1024P FeaturesNotational conventions Using this DocumentTypographical conventions Special messagesAsus contact information Getting to Know the GigaX 1024P Parts ListRear Panel Front PanelTechnical Specifications Part 1 Connecting the Hardware Installing the Switch on a Flat SurfaceMounting the Switch in a Rack Part 2 -Start the Switch Connect to the PC with CNM InstalledConnect to computers or a LAN LED Indicators Attach the power cordManagement from CNM Switch Discovery and ManagementAvailable Switches Factory Default Setting Password RecoveryStart CNM Program Management FunctionsTop frame Functional LayoutTree view of the network topology Topology General Settings for CNMAdd Switch Help SetupTopology Discovery Switch Topology11. Add Switch Switch Add and RemovalTopology Load and Save 12. Remove Switch2. Description of Commonly Used Buttons and Icons Switch SetupSystem Reboot14. Link Status Link Status14b. Change Password Change Password15. Load LoadSave 16. Save ConfigurationApply and Save 17. Apply ConfigurationPhysical Interface ConfigurationLink Aggregation Enable or disable a portBandwidth 20. Bandwidth ConfigurationTraffic Control Vlan Setup21. Vlan 23. Igmp Snoop Igmp Snooping24. QoS Setup QoS SetupPort Traffic Statistics26. Traffic History Traffic History27. Port Comparison Comparison