Asus GIGAX1024P warranty Igmp Snooping

Page 37

English

7.VLAN function: enable or disable the VLAN function.

8.Unicast packet inter-VLAN leaky: to enable the packet to be forwarded to a destination port (L2 table hit) at different VLAN.

9.ARP broadcast packet inter-VLAN leaky: to enable ARP frame to broadcast to all switch ports.

10.IP multicast packet inter-VLAN leaky: to enable IP multicast packet to be flooded to all the multicast address group member set ignore the VLAN member set domain limitation.

11.802.1Q VLAN tag aware: to enable tag-based VLAN function.

12.Ingress rule for acceptable frame types: to admit all frames or to admin only VLAN-tagged frames.

13.Ingress rule for ingress filtering: to enable filter the frame received from a port which port is not included in the classified VLAN group member.

4.7.6 IGMP Snooping

Enable the IGMP snooping will let the switch learn the multicast router port and group address member ports into the multicast address table. The table is combined with L2 MAC table, so the maximum entry is 8K. The valid port member will auto aging out after about 5 minute idle. Figure 4.23 shows the page.

Figure 4.23. IGMP Snoop

36

GigaX Centralized Network Management User’s Manual

Page 36 Page 38
Image 37
Page 36 Page 38
Contents Copyright Information Centralized Network Management Table of Contents Introduction GigaX 1024P FeaturesNotational conventions Using this DocumentTypographical conventions Special messagesAsus contact information Getting to Know the GigaX 1024P Parts ListRear Panel Front PanelTechnical Specifications Installing the Switch on a Flat Surface Part 1 Connecting the HardwareMounting the Switch in a Rack Connect to the PC with CNM Installed Part 2 -Start the SwitchConnect to computers or a LAN LED Indicators Attach the power cordManagement from CNM Switch Discovery and ManagementAvailable Switches Factory Default Setting Password RecoveryStart CNM Program Management FunctionsTop frame Functional LayoutTree view of the network topology Topology General Settings for CNMAdd Switch Help SetupTopology Discovery Switch Topology11. Add Switch Switch Add and RemovalTopology Load and Save 12. Remove Switch2. Description of Commonly Used Buttons and Icons Switch SetupSystem Reboot14. Link Status Link Status14b. Change Password Change Password15. Load LoadSave 16. Save ConfigurationApply and Save 17. Apply ConfigurationPhysical Interface ConfigurationLink Aggregation Enable or disable a port Bandwidth 20. Bandwidth ConfigurationTraffic Control Vlan Setup21. Vlan 23. Igmp Snoop Igmp Snooping24. QoS Setup QoS SetupPort Traffic Statistics26. Traffic History Traffic History27. Port Comparison Comparison
Top Page Image Contents