Bosch Appliances 3122 475 22015en manual Radiator status indication, Mounting the radiators

Page 49

INTEGRUS Installation and User Instructions Integrus Radiators

en 43

 

 

3.1.2 Radiator status indication

A radiator consists of two IRED panels. Each IRED panel has an amber and a red indicator LED (see figure 3.2) which show the status of the radiator panel

Red LED

Amber LED

Status

on

off

Stand-by mode

 

 

 

off

on

Transmitting

flashing

on

At switch-on:

 

 

Initialising signal equalisation

 

 

During operation:

 

 

Temperature protection mode.

 

 

See chapter 6,

 

 

Trouble-shooting

 

 

 

 

on

on IRED panel failure.

 

 

See chapter 6,

 

 

Trouble-shooting

 

 

 

3.1.3 Mounting the radiators

Radiators in permanent installations can be either fixed to a wall, hung under a ceiling or balcony or secured to any sturdy material, using the suspension bracket supplied with the radiator. The mounting angle can be adjusted for optimal coverage.

For wall mounting a separate bracket (LBB 3414/00) is also required. In non-permanent installations, a floor stand can be used.

Warning: When you install the radiator in a ceiling, you must leave at least 1 m3 of free space around the back of the radia- tor. To prevent the radiator from becom- ing too hot, make sure that there is a good airflow in this free space.

Note: When in operation, the radiators may feel warm to the touch. This is quite normal, and does not indicate a radiator fault or malfunction.

Warning: Always ensure that natural air- flow is not obstructed by ceilings, walls etc. when determining the position of the radiator. Leave plenty of space around the radiator to prevent it becoming too hot.

Attaching the suspension bracket

First assemble the supplied suspension bracket and connect it to the radiator (see figure 3.3 and figure 3.4). This bracket is attached to the radiator by two bolts with washers. There are corresponding holes on the back of the radiators. There is also a spring-loaded plunger (indicated by a black arrow in figure 3.4), located above the bolt hole on the right-hand arm of the bracket, which is used for adjusting the angle of the radiator (shown in inset in figure 3.4). There are corre- sponding holes on the back of the radiator for accept- ing this plunger. The mounting angle can be adjusted in steps of 15°.

Figure 3.3 Attaching the plate to the suspension bracket

Figure 3.4 Attaching the suspension bracket to the radiator

Bosch Security Systems 2005-04 3122 475 22015en

Page 48 Page 50
Image 49
Page 48 Page 50
Contents Integrus Important Safeguards Table of contents Integrus Installation and User Instuctions Table of contents Bosch Security Systems 2005-04 3122 475 22015en Integrus Installation and User Instructions System overview System description and planningSystem technology Signal ProcessingIR radiation Quality modesCarriers and channels Aspects of infra-red distribution systemsDirectional sensitivity of the receiver Footprint of the radiatorRadiator mounted at 45 to the ceiling Ambient lightingPositioning the radiators 11 Infra-red signal blocked by a person in frontOverlapping footprints and multipath effects 14 Combination of several reflected signalsRectangular footprints Planning an Integrus infra-red radiation systemCabling Planning radiatorsSystem with one transmitter Setting the radiator delay switches20m System with two or more transmitters in one room Calculation of the master-to-slave signal delays Testing the coverage area Interference from IR systems Description Integrus TransmittersIntegrus DCN interface module Audio interface modulesInterface module slot cover Mounting an interface module in the transmitter housingRemoving the main PCB and the rear panel Upgrading an LBB4502/xx to an INT-TXRemoving the main PCB and the rear panel steps 1 Installation of the INT-TXKInstallation of the INT-TXK steps 1 Connecting the DCN Next Generation Connecting the DCN systemConnecting other external audio sources ConnectionsConnecting to another transmitter Connecting an emergency signalOverview Using the configuration menuTo navigate through the Main menu Navigate through the menuTo jump to a sub-menu To navigate through a sub-menuTo jump back from a sub-menu to an item of the Main menu ExamplesExample 1 Disable carrier 2. See also section Turn to move the cursor Required channel num Setup Back Start-up Configuration and operationMain menu View transmitter statusDCN View fault statusView version information Set monitoring optionsSet network mode Set transmission modeSet number of channels Set channel quality and assign inputs to channels Per Channel Settings Set channel names View carrier assignments Disable or enable carriersConfigure auxiliary inputs Enable / disable headphone output Enable / disable IR-monitoringPer Input Sensitivity settings Set sensitivity of the inputsChoose transmitter name Reset all options to factory default valuesIntegrus Radiators Medium and High Power RadiatorsDescription Mounting the radiators Radiator status indicationAttaching the suspension bracket Wall mounting Mounting on a floor standCeiling mounting Connecting radiators to the transmitterMounting on horizontal surfaces Using the output power selection switch Low Power Wide Beam RadiatorLimitations Mounting the RadiatorIntegrus Receivers Receiver headphones Reception test modeOperation LBB 4560 Charging unit Integrus Charging UnitsWall mounting the charging cabinet Charging procedureTroubleshooting Integrus Installation and User Instructions Troubleshooting System Specification Technical DataTransmitter Upgrade Kit range Radiators and AccessoriesMedium and High Power Radiators Transmitters and ModulesLow Power Wide Beam Radiator Receivers, Battery Packs and Charging UnitsNiMH Battery Pack Wall Mounting BracketConnection details Guaranteed rectangular footprints Angle Product index

3122 475 22015en specifications

Bosch Appliances are synonymous with quality and innovation, and the model 3122 475 22015en showcases these attributes elegantly. This appliance combines advanced engineering with intuitive design, making it a valuable addition to any modern kitchen.

One of the standout features of the Bosch 3122 475 22015en is its efficiency. Designed to optimize performance while using minimal energy, this appliance is ideal for environmentally-conscious consumers. It complies with strict energy standards, ensuring that it not only delivers superior results but also helps in reducing household energy bills.

The appliance is equipped with cutting-edge technology that enhances its functionality. One significant innovation is the EcoSilence Drive, which ensures powerful performance with minimal noise. This makes the Bosch 3122 475 22015en an excellent choice for open-concept living spaces or homes where silence is valued.

Another noteworthy aspect is its PrecisionWash technology. This intelligent feature uses sensors to detect soil levels, adjusting the wash cycle for optimal cleaning power. This ensures that every dish, regardless of the load, comes out sparkling clean, thus providing peace of mind for users who value cleanliness.

The design of the Bosch 3122 475 22015en is sleek and modern, with a stainless-steel finish that complements contemporary kitchen aesthetics. Its ergonomic controls are intuitive and user-friendly, making operation straightforward even for those who are not technologically savvy.

In addition to its performance and aesthetics, safety is also a priority in the design of this appliance. It includes multiple safety features such as a Child Lock for added peace of mind, ensuring a safe environment for households with young children.

Furthermore, this model incorporates flexible loading options, including adjustable racks and foldable tines, allowing users to customize the interior space to accommodate various sizes and shapes of dishes. This adaptability maximizes utility and enhances user experience.

In conclusion, the Bosch Appliances 3122 475 22015en is a perfect blend of performance, efficiency, and innovative technology. With features like EcoSilence Drive and PrecisionWash, alongside a focus on safety and flexibility, it truly embodies Bosch's commitment to creating high-quality appliances that meet the needs of modern living. Whether you are an avid chef or simply enjoy hosting, this appliance is designed to make everyday tasks easier and more efficient.
Top Page Image Contents