Bosch Appliances 3122 475 22015en manual Connecting radiators to the transmitter, Ceiling mounting

Page 51

INTEGRUS Installation and User Instructions Integrus Radiators

en 45

 

 

The radiator (plus suspension bracket) is attached to the wall bracket by sliding the mounting bolt over the slot on the wall bracket and then tightening it (see figure 3.9). A split pin is then inserted into a small hole in the bolt to stop it from working loose (see inset in figure 3.9). The vertical angle of the radiator can be adjusted between 0 and 90° in steps of 15°. The hori- zontal orientation of the radiator can be adjusted by loosening the bolt then turning the radiator to the required position.

Figure 3.8 Attaching the wall mounting bracket to a wall

Ceiling mounting

The radiators can be attached to the ceiling using the supplied suspension bracket. This ensures enough space for a proper air flow around the radiator. Mounting a radiator in the ceiling will in most cases require a forced air flow by means of a ventilator to prevent overheating.

Mounting on horizontal surfaces

When the radiator has to be positioned a horizontal surface (e.g. on top of an interpreter booth), the dis- tance between the radiator and the surface must be at least 4 cm (1.5 inch) to enable enough air flow around the radiator. This can be achieved by using the suspen- sion bracket as a support. If this is not possible, switch the radiator to half power. If the radiator is used at full power on top of an interpreter booth, the ambient tem- perature must not exceed 35° C.

3.1.4Connecting radiators to the transmitter

The transmitter has six BNC HF Output connectors labelled 1, 2, 3, 4, 5 and 6 on the rear panel. All six outputs are functionally identical. They can each drive up to 30 radiators (LBB 4511/00 and/or LBB 4512/00) in a loop-through configuration. The radiators are con- nected with RG59 cables. The maximum cable length per output is 900 m (2970 ft) to the last radiator. Automatic cable termination is achieved by a built-in switch in the BNC connectors on the radiator.

Notes:

•For the automatic cable termination to work, never leave an open-ended cable connected to the last radiator in a loop-through chain.

•When connecting infra-red radiators, do not split the cable, else the system will not function correctly.

Figure 3.9 Attaching the radiator to the wall mounting bracket

Bosch Security Systems 2005-04 3122 475 22015en

Page 50 Page 52
Image 51
Page 50 Page 52
Contents Integrus Important Safeguards Table of contents Integrus Installation and User Instuctions Table of contents Bosch Security Systems 2005-04 3122 475 22015en Integrus Installation and User Instructions System overview System description and planningQuality modes Signal ProcessingSystem technology IR radiationFootprint of the radiator Aspects of infra-red distribution systemsCarriers and channels Directional sensitivity of the receiverRadiator mounted at 45 to the ceiling Ambient lightingPositioning the radiators 11 Infra-red signal blocked by a person in frontOverlapping footprints and multipath effects 14 Combination of several reflected signalsRectangular footprints Planning an Integrus infra-red radiation systemCabling Planning radiatorsSystem with one transmitter Setting the radiator delay switches20m System with two or more transmitters in one room Calculation of the master-to-slave signal delays Testing the coverage area Interference from IR systems Description Integrus TransmittersIntegrus DCN interface module Audio interface modulesInterface module slot cover Mounting an interface module in the transmitter housingRemoving the main PCB and the rear panel Upgrading an LBB4502/xx to an INT-TXRemoving the main PCB and the rear panel steps 1 Installation of the INT-TXKInstallation of the INT-TXK steps 1 Connections Connecting the DCN systemConnecting the DCN Next Generation Connecting other external audio sourcesConnecting to another transmitter Connecting an emergency signalOverview Using the configuration menuTo navigate through a sub-menu Navigate through the menuTo navigate through the Main menu To jump to a sub-menuTo jump back from a sub-menu to an item of the Main menu ExamplesExample 1 Disable carrier 2. See also section Turn to move the cursor Required channel num Setup Back View transmitter status Configuration and operationStart-up Main menuDCN View fault statusView version information Set monitoring optionsSet network mode Set transmission modeSet number of channels Set channel quality and assign inputs to channels Per Channel Settings Set channel names View carrier assignments Disable or enable carriersConfigure auxiliary inputs Set sensitivity of the inputs Enable / disable IR-monitoringEnable / disable headphone output Per Input Sensitivity settingsChoose transmitter name Reset all options to factory default valuesMedium and High Power Radiators Integrus RadiatorsDescription Radiator status indication Mounting the radiatorsAttaching the suspension bracket Wall mounting Mounting on a floor standConnecting radiators to the transmitter Ceiling mountingMounting on horizontal surfaces Using the output power selection switch Low Power Wide Beam RadiatorLimitations Mounting the RadiatorIntegrus Receivers Reception test mode Receiver headphonesOperation LBB 4560 Charging unit Integrus Charging UnitsWall mounting the charging cabinet Charging procedureTroubleshooting Integrus Installation and User Instructions Troubleshooting System Specification Technical DataTransmitters and Modules Radiators and AccessoriesTransmitter Upgrade Kit range Medium and High Power RadiatorsWall Mounting Bracket Receivers, Battery Packs and Charging UnitsLow Power Wide Beam Radiator NiMH Battery PackConnection details Guaranteed rectangular footprints Angle Product index

3122 475 22015en specifications

Bosch Appliances are synonymous with quality and innovation, and the model 3122 475 22015en showcases these attributes elegantly. This appliance combines advanced engineering with intuitive design, making it a valuable addition to any modern kitchen.

One of the standout features of the Bosch 3122 475 22015en is its efficiency. Designed to optimize performance while using minimal energy, this appliance is ideal for environmentally-conscious consumers. It complies with strict energy standards, ensuring that it not only delivers superior results but also helps in reducing household energy bills.

The appliance is equipped with cutting-edge technology that enhances its functionality. One significant innovation is the EcoSilence Drive, which ensures powerful performance with minimal noise. This makes the Bosch 3122 475 22015en an excellent choice for open-concept living spaces or homes where silence is valued.

Another noteworthy aspect is its PrecisionWash technology. This intelligent feature uses sensors to detect soil levels, adjusting the wash cycle for optimal cleaning power. This ensures that every dish, regardless of the load, comes out sparkling clean, thus providing peace of mind for users who value cleanliness.

The design of the Bosch 3122 475 22015en is sleek and modern, with a stainless-steel finish that complements contemporary kitchen aesthetics. Its ergonomic controls are intuitive and user-friendly, making operation straightforward even for those who are not technologically savvy.

In addition to its performance and aesthetics, safety is also a priority in the design of this appliance. It includes multiple safety features such as a Child Lock for added peace of mind, ensuring a safe environment for households with young children.

Furthermore, this model incorporates flexible loading options, including adjustable racks and foldable tines, allowing users to customize the interior space to accommodate various sizes and shapes of dishes. This adaptability maximizes utility and enhances user experience.

In conclusion, the Bosch Appliances 3122 475 22015en is a perfect blend of performance, efficiency, and innovative technology. With features like EcoSilence Drive and PrecisionWash, alongside a focus on safety and flexibility, it truly embodies Bosch's commitment to creating high-quality appliances that meet the needs of modern living. Whether you are an avid chef or simply enjoy hosting, this appliance is designed to make everyday tasks easier and more efficient.
Top Page Image Contents