Dell E5550 owner manual Installing the Display Assembly, Removing the Display Bezel

Page 29

Installing the Display Assembly

1.Place the display assembly to align with the screw holders on the computer.

2.Route the WWAN, WLAN, and display cables through their routing channels.

3.Tighten the screws to secure the display assembly to the computer.

4.Connect the WWAN and WLAN cables to their connectors.

5.Connect the display cable to the system board, place the display-cable bracket over the connector, and tighten the screw to secure the display cable to the computer.

6.Install the:

a.display-hinge brackets

b.palmrest

c.keyboard

d.keyboard trim

e.battery

f.base cover

7.Follow the procedures in After Working Inside Your Computer.

Removing the Display Bezel

1.Follow the procedures in Before Working Inside Your Computer.

2.Pry the edges to release the display bezel from the display assembly.

29

Image 29

Contents Dell Latitude E5550 Page Before Working Inside Your Computer Working on Your ComputerTurning Off Your Computer After Working Inside Your Computer System Overview Recommended ToolsFront and Back View Removing the Base Cover Installing the Base CoverRemoving the Battery Removing the Hard-Drive Assembly Installing the BatteryBase cover Battery Installing the Hard-Drive Assembly Removing the Keyboard Trim Installing the MemoryRemoving the Memory Removing the Keyboard Installing the Keyboard TrimRemoving the Palmrest Installing the KeyboardBase cover Battery Keyboard trim Removing the Power-Switch Board Installing the PalmrestRemoving the SmartCard Reader Board Installing the Power-Switch BoardPage Removing the USH Board Installing the SmartCard-Reader BoardRemoving the Finger-Print Reader Board Installing the USH BoardRemoving the LED Board Installing the Finger-Print Reader BoardRemoving the Power-Connector Port Installing the LED BoardInstalling the power-connector port Removing the Wlan Card / WiGig Card Installing the Wlan Card / WiGig CardRemoving the Wwan Card Installing the Wwan CardRemoving the Display-Hinge Brackets Removing the Display Assembly Installing the Display-Hinge BracketsPage Removing the Display Bezel Installing the Display AssemblyRemoving the Display Panel Installing the Display BezelPage Removing the Display Hinges Installing the Display PanelRemoving the Camera Installing the Display HingesRemoving the eDP Cable Installing the CameraRemoving the System Fan Installing the eDP cableRemoving the Audio Board Installing the System FanRemoving the System Board Installing the Audio BoardPage Removing the Coin-Cell Battery Installing the System BoardRemoving the Heatsink Installing the Coin-Cell BatteryInstalling the Heatsink Removing the Speakers Installing the Speakers Uefi System Setup OptionsECP PS2COM2 COM3Page Video Secure Boot KEK Power Management Post Behavior Wwan Wwan / GPS 4MB Technical SpecificationsUMA USB Feature Specification Active Area Axis 99.50 mm 53.00 mm AC Adapter Environmental Enhanced Pre-Boot System Assessment ePSA Diagnostics DiagnosticsDevice Status Lights Post Battery Status LightsContacting Dell