Dell E5550 owner manual After Working Inside Your Computer

Page 5

*On the Home screen, click and then select Shut down.

In Windows 7:

1.Click Start.

2.Click Shut Down.

or

1.Click Start.

2.Click the arrow in the lower-right corner of the Start menu as shown below, and then click

Shut Down .

2.Ensure that the computer and all attached devices are turned off. If your computer and attached devices did not automatically turn off when you shut down your operating system, press and hold the power button for about 6 seconds to turn them off.

After Working Inside Your Computer

After you complete any replacement procedure, ensure you connect any external devices, cards, and cables before turning on your computer.

CAUTION: To avoid damage to the computer, use only the battery designed for this particular Dell computer. Do not use batteries designed for other Dell computers.

1.Connect any external devices, such as a port replicator or media base, and replace any cards, such as an ExpressCard.

2.Connect any telephone or network cables to your computer.

CAUTION: To connect a network cable, first plug the cable into the network device and then plug it into the computer.

3.Replace the battery.

4.Replace the base cover.

5.Connect your computer and all attached devices to their electrical outlets.

6.Turn on your computer.

5

Image 5
Contents Dell Latitude E5550 Page Before Working Inside Your Computer Working on Your ComputerTurning Off Your Computer After Working Inside Your Computer System Overview Recommended ToolsFront and Back View Removing the Base Cover Installing the Base CoverRemoving the Battery Removing the Hard-Drive Assembly Installing the BatteryBase cover Battery Installing the Hard-Drive Assembly Removing the Keyboard Trim Installing the MemoryRemoving the Memory Removing the Keyboard Installing the Keyboard TrimRemoving the Palmrest Installing the KeyboardBase cover Battery Keyboard trim Removing the Power-Switch Board Installing the PalmrestRemoving the SmartCard Reader Board Installing the Power-Switch BoardPage Removing the USH Board Installing the SmartCard-Reader BoardRemoving the Finger-Print Reader Board Installing the USH BoardRemoving the LED Board Installing the Finger-Print Reader BoardRemoving the Power-Connector Port Installing the LED BoardInstalling the power-connector port Removing the Wlan Card / WiGig Card Installing the Wlan Card / WiGig CardRemoving the Wwan Card Installing the Wwan CardRemoving the Display-Hinge Brackets Removing the Display Assembly Installing the Display-Hinge BracketsPage Removing the Display Bezel Installing the Display AssemblyRemoving the Display Panel Installing the Display BezelPage Removing the Display Hinges Installing the Display PanelRemoving the Camera Installing the Display HingesRemoving the eDP Cable Installing the CameraRemoving the System Fan Installing the eDP cableRemoving the Audio Board Installing the System FanRemoving the System Board Installing the Audio BoardPage Removing the Coin-Cell Battery Installing the System BoardRemoving the Heatsink Installing the Coin-Cell BatteryInstalling the Heatsink Removing the Speakers Installing the Speakers Uefi System Setup OptionsECP PS2COM2 COM3Page Video Secure Boot KEK Power Management Post Behavior Wwan Wwan / GPS 4MB Technical SpecificationsUMA USB Feature Specification Active Area Axis 99.50 mm 53.00 mm AC Adapter Environmental Enhanced Pre-Boot System Assessment ePSA Diagnostics DiagnosticsDevice Status Lights Post Battery Status LightsContacting Dell