General Dynamics UP/DN CONVERTER L-BAND, LT-3600 manual Part Number Configuration

Integrated L-Band Up/Dn Converter LT3600 CG-1309

1.8 Part Number Configuration

The Part Number Selection Chart shows configuration options that are set at the factory prior to shipment. The voltage output to J4 and J10 may be changed as required by the customer, however this requires removal of the cover and resetting internal jumper connections. This should be performed by qualified personnel.

Base		1st Digit		2nd Digit		3rd Digit		4th Digit
Number		IF Operation		L-Band		Bias Voltage		Ref. Oscillator
201667	-	1	70 MHZ	1	Std.	0	None	0	Std 10Mhz
							D/C-22VDC
		2	140 MHz	2	Extend	1		1	Hi Accuracy
							U/C-22VDC		10 MHz
						2	D/C-22VDC
							U/C-15VDC

5th Digit		6th Digit		7th Digit
L-Band Ports		10 MHZ Ref. Out		StarSwitch Ready
0	SMA Female	0	No Output	0	No
1	N-Type Female	1	U/C & D/C	1	Yes
		2	U/C Only
		3	D/C Only

Note: If connected to a StarSwitch, No Bias Voltage Output is allowed.

Option Descriptions:

1st Digit – IF Frequency, Options 3 and 4 are set for inverted spectrum.

2nd Digit – Standard – 950 to 1525 MHz, Extended – 950 to 1950 MHz

3rd Digit – Bias voltage outputs are switchable in rear panel, if selected.

4th Digit – A reference oscilator is built in to the main board. The high accuracy unit is optional. 5th Digit – D/C Input and U/C Output Port Type (J4 & J10)

6th Digit – The output from the 10 MHz reference oscilator may be connected to either or both. 7th Digit – StarSwitch Ready includes output connections to J5 and J8 for control between the

Starswitch and the LT3600.

Page 8