Front Panel w/Keypad and LCD Display | General Dynamics LT-3600

Integrated L-Band Up/Dn Converter LT3600	CG-1309

1.4 SPECIFICATIONS

The specifications for the Integrated L-Band Up/Dn Converter are listed in Table 1-1, along with the mechanical dimensions.

1.5 FRONT PANEL

All the operating controls and indicators for the Integrated L-Band Up/Dn Converter are located on the front panel. The front panel is depicted in Figure 1-1. Alarm and level monitoring of the L-Band Up/Dn Converter CCA, an external LNB, and SSPB modules is accomplished through the front panel display and keboard interface.

1.6 REAR PANEL

The rear panel is depicted in Figure 1-2. It incorporates, from left to right, Grounding Lug (GND), Power Connector, Optional 10MHz high stability reference output (J1), 10 MHz reference input (J2), IF Out (J3), L-Band In

(J4), On/Off Switch for Dc output on J4 (SW2), Cooling Fans, Down Converter StarSwitch Interface (Opt.) (J5), SSPB monitor and control (J6), Remote Serial Interface (J7), Up Converter StarSwitch Interface (Opt.) (J8), IF In (J9), On/Off Switch for Dc output on J10 (SW3), L-Band Out (J10).

In the lower right hand side of the rear panel is a label that refers to the operation and maintenance manual and revision level that applies to this converter.

1.7 COOLING

Cooling of the equipment is achieved by pulling in cool air through the two side inlet grills. The heated air exits the equipment through the two rear panel mounted exhaust fans.

Figure 1-1 Front Panel w/Keypad and LCD Display

Figure 1-2 Rear Panel

Page 7