EnGenius Technologies EAP350 manual Wireless Advanced Data Rate, Transmit Power, RTS/CTS Threshold

Page 38

37

Wireless Advanced

Data Rate	Select a data rate from the drop-down list. The data rate affects throughput. If you select a low
	data rate value, the throughput is reduced but the transmission distance increased.

Transmit Power	Set desired output power of the wireless signal.

RTS/CTS Threshold	Specify the threshold package size for RTC/CTS. A smaller number causes RTS/CTS packets to be
	sent more often and consumes more bandwidth.

Distance	Specify the distance between Access Points and clients. Longer distances may reduce high-speed
	connections.

Short GI	Sets the time that the receiver waits for RF reflections to settle out before sampling data. Using a
	short (400ns) guard interval can increase throughput, but it can also increase error rate in some
	installations due to increased sensitivity to radio-frequency reflections. Select the option that
	works best for your installation.

Aggregation	Merges data packets into one packet. This option reduces the number of packets, but increases
	packet sizes.

Wireless Traffic	Check this option to enable wireless traffic shaping. Traffic shaping regulates the flow of packets
Shaping	leaving an interface to deliver improved Quality of Service.

Incoming Traffic Limit	Specify the wireless transmission speed used for downloading.

Outgoing Traffic Limit	Specify the wireless transmission speed used for uploading.

Accept / Cancel	Click [Accept] to confirm the changes or [Cancel] to cancel and return previous settings.

Image 38

Contents EAP350 Table of Contents Error! Bookmark not definedAppendix a FCC Interference Statement Building a Wireless NetworkManagement Date Revision HistoryVersion Features and Benefits IntroductionPackage Contents System Requirements ApplicationsSmall Office and Home Office Soho Networks Wireless Extensions to Ethernet networksWired LAN backup Training/Educational facilitiesConsiderations for Wireless Installation Before you BeginComputer Settings Windows XP/Windows Page Page Select Network in the Internet & Network section Configure IPv4, select ManuallyApple Mac X OS Hardware Installation Front Panel Rear Panel Default Settings Configuring Your Access PointDefault Settings Web Configuration If successful, you will see the EAP350 User Menu Status Save/ReloadMain Page Wireless Client List System Log Refresh Update the log Clear Clear the log System LogOperation Mode SystemSystem Properties Device Name Operation ModeAccept / Cancel Country/RegionIP Settings This page allows you to modify the devices IP settingsSpanning Tree Spanning Tree Status Spanning Tree SettingBridge Forward Delay Bridge Hello TimePage Wireless Wireless NetworkExtension Channel Wireless Network Wireless ModeChannel HT Mode Channel / FrequencySpecify the Ssid for current profile Ssid ProfileSsid Profile Specify the Vlan tag for the current profileWireless Security WEP EncryptionDefault Key Encryption Key #WPA-PSK WPA Pre-Shared Key Encryption WPA Pre-Shared Key EncryptionWPA Encryption Wireless MAC Filter Wireless Filter Access Point / WDS AP modeWireless Advanced Wireless Traffic Wireless Advanced Data RateTransmit Power RTS/CTS ThresholdWPS Wi-Fi Protected Setup WPS Current Status Wi-Fi Protected Setup WPSAuthentication Mode Self Pin CodeWDS Link Settings WDS Link Settings MAC Address Administration ManagementManagement Vlan Management VlanSnmp SnmpPage Backup/Restore Firmware Upgrade To perform the Firmware UpgradeAutomatically Get Date Time SettingTime Manually Set Date and Time TimeLog Diagnosis LED Control Logout Reset Building a Wireless Network Access Point ModeAccess Point Mode with WDS Function WDS AP mode WDS Bridge Mode Federal Communication Commission Interference Statement FCC Radiation Exposure Statement