EnGenius Technologies EAP350 manual Spanning Tree Setting, Spanning Tree Spanning Tree Status

Page 27

26

5.3 Spanning Tree Setting

This page allows you to modify the Spanning Tree settings. Enabling Spanning Tree protocol will prevent network loops in your LAN network.

Spanning Tree

Spanning Tree Status

Enable or disable the Spanning Tree function.

 

 

Bridge Hello Time

Specify Bridge Hello Time in seconds. This value determines how often EAP350 sends hello

 

packets and communicate information about the topology throughout the entire Bridged Local

 

Area Network.

 

 

Bridge Max Age

Specify Bridge Max Age in seconds. If another bridge in the spanning tree does not send a hello

 

packet for a long period of time, it is assumed to be dead.

 

 

Bridge Forward Delay

Specify Bridge Forward Delay in seconds. Forwarding Delay time is the time spent in each of the

 

Listening and Learning states prior the Forwarding state was entered. This delay is provided so

 

that when a new bridge comes on to a busy network, it looks at traffic info before participating.

 

 

Image 27
Contents EAP350 Error! Bookmark not defined Table of ContentsBuilding a Wireless Network ManagementAppendix a FCC Interference Statement Revision History VersionDate Introduction Features and BenefitsPackage Contents Applications System RequirementsTraining/Educational facilities Wireless Extensions to Ethernet networksWired LAN backup Small Office and Home Office Soho NetworksBefore you Begin Considerations for Wireless InstallationComputer Settings Windows XP/Windows Page Page Configure IPv4, select Manually Apple Mac X OSSelect Network in the Internet & Network section Hardware Installation Front Panel Rear Panel Configuring Your Access Point Default SettingsDefault Settings Web Configuration If successful, you will see the EAP350 User Menu Save/Reload StatusMain Page Wireless Client List System Log System Log Refresh Update the log Clear Clear the logSystem Operation ModeCountry/Region Operation ModeAccept / Cancel System Properties Device NameThis page allows you to modify the devices IP settings IP SettingsBridge Hello Time Spanning Tree SettingBridge Forward Delay Spanning Tree Spanning Tree StatusPage Wireless Network WirelessChannel / Frequency Wireless Network Wireless ModeChannel HT Mode Extension ChannelSpecify the Vlan tag for the current profile Ssid ProfileSsid Profile Specify the Ssid for current profileWEP Encryption Wireless SecurityEncryption Key # Default KeyWPA Pre-Shared Key Encryption WPA-PSK WPA Pre-Shared Key EncryptionWPA Encryption Wireless Filter Access Point / WDS AP mode Wireless MAC FilterWireless Advanced RTS/CTS Threshold Wireless Advanced Data RateTransmit Power Wireless TrafficWPS Wi-Fi Protected Setup Self Pin Code Wi-Fi Protected Setup WPSAuthentication Mode WPS Current StatusWDS Link Settings WDS Link Settings MAC Address Management AdministrationManagement Vlan Management VlanSnmp SnmpPage Backup/Restore To perform the Firmware Upgrade Firmware UpgradeTime Time SettingTime Manually Set Date and Time Automatically Get DateLog Diagnosis LED Control Logout Reset Access Point Mode Building a Wireless NetworkAccess Point Mode with WDS Function WDS AP mode WDS Bridge Mode FCC Radiation Exposure Statement Federal Communication Commission Interference Statement