SmartPath Enterprise Wireless Access Point, Outdoor Installation Guide
This guide explains how to mount an Black Box LWN602WA Outdoor Access Point to a pole or flat surface in virtually any out- door setting, and connect it to Black Box SmartPath EMS Network Management over the network. To register, get the latest product documentation, see compliance information, and download software updates, contact Black Box Technical Support at
1. Kit Contents
The LWN602WA kit includes the items listed below and shown in Figure 1.
•(1) outdoor access point
•(1) plane bracket
•(1) base bracket
•(4)
•(4) round head screws 1⁄4”, lock washer, flat washer
•(4) hex head bolts, 3⁄8”x1⁄2” (10 mm x 13 mm), lock Washer, flat Washer 1⁄2” (13 mm)
•(1) hose strap
•(1) ground cable
•(1) Ethernet housing
Figure 1. LWN602WA kit contents.
To install your LWN602WA, you will need the following accessories (ordered separately) and tools:
•(1) SmartPath LWN602WA Antenna kit containing (2) 2.4-GHz antennas and (2) 5-GHz antennas (LWN600A-WANTK)
•A switch that provides PoE power, or a PoE provisioning device
•(1) shielded CAT5 Ethernet cable rated for outdoor use; length not to exceed 328 feet (100 m)
•Crosshead screwdriver for 1⁄4” (6 mm) x 3⁄8” (10 mm) screws
•Drive sockets (nut drivers) for 3⁄8” (10 mm) nuts
•Flat-blade screwdriver to tighten hose clamp
2. Safety Instructions and Site Hazard Warnings
Read and follow these safety instructions and hazard warnings before installing an LWN602WA outdoors. Keep these instructions for future reference.
•To comply with
•You can install the LWN602WA in wet, windy locations. Therefore, make sure to install the Ethernet cable housing for a complete waterproof connection.
Page 3 |