Cisco Systems VG350 specifications Power Source, Power Suppy Considerations

Chapter 3 Planning Your Installation

Location and Mounting Requirements

Power Source

A Cisco VG350 Voice Gateway with AC power supply autoselects either 100–127 volt or 200–240 volt operation. AC versions include a 6-foot (1.8-meter) electrical power cord. (A label near the power cord indicates the correct voltage, frequency, current draw, and power dissipation.)

Power Suppy Considerations

Cisco VG350 Voice Gateway requires significantly more power because of its high-density ports and OPX ‘Lite’ requirements.

This require a larger 48V battery backup that may need to be custom built.

To handle power failure conditions, an uninterrupted power supply (UPS) is needed. UPS is widely available in all markets, including emerging markets (due to prevalence of UPS for personal computers). Thus, a separate UPS for Cisco VG350 Voice Gateway is a viable option when the ISR/UPS is not co-located with it.

If you suspect that your AC power is not clean—if lights flicker often or there is machinery with large motors nearby—have a qualified person test the power. Install a power conditioner if necessary.

Warning Do not work on the system or connect or disconnect cables during periods of lightning activity. Statement 1001

Warning Read the installation instructions before you connect the system to its power source. Statement 1004

Warning This product relies on the building’s installation for short-circuit (overcurrent) protection. Ensure that the protective device is rated not greater than:120 VAC, 15A U.S. (240 VAC, 10A international) Statement 1005

Warning The device is designed for connection to TN and IT power systems. Statement 1007

Warning This unit is intended for installation in restricted access areas. A restricted access area can be accessed only through the use of a special tool, lock and key, or other means by security. Statement 1017

Cisco VG350 Voice Gateway Hardware Installation Guide

OL-25970-01 3-3