Black Box LPB716A manual Installation, Power On, Installing Switch to a 19-Inch Wiring Closet Rail

Page 13

Chapter 3: Installation

3.1.3 Power On

The switch supports a 100-240 VAC, 50-60 Hz power supply. The power supply will automatically convert the local AC power source to DC power. It does not matter whether any connection is plugged into the switch or not when powering on. After the power is on, all LED indicators will light immediately and then all go off except the power LED, which stays on.

3.2 Installing Switch to a 19-Inch Wiring Closet Rail

CAUTION: Allow a proper spacing and proper air ventilation for the cooling fan at both sides of the switch. Wear a grounding device for electrostatic discharge.

1.Using two screws (included), attach the rackmount ears to the switch’s left and right sides. See Figure 3-2.

2.Line up the mounting holes on the switch assembly (the switch with rackmount ears installed) with the mounting holes on a 19" wiring closet rack. Install two screws (included) to hold the switch in place in the rack.

Figure 3-2. Install the switch chassis in a 19"rack.

3.3 Cabling Requirements

To ensure a successful installation and maintain proper network performance, use the required cable types. Cables with lesser specification will cause the LAN to work poorly.

For a Fast Ethernet TP network connection, the cable grade must be CAT5 or CAT5e that‘s up to 328 feet (100 meters) long.

724-746-5500 l www.blackbox.com 13

Image 13

Contents 16-/24-Port 10/100 PoE PSE Web Smart Switch 16-/24-Port 10/100 PoE PSE Web Smart Switch NOM Statement and CE Directive Normas Oficiales Mexicanas NOM Electrical Safety StatementTable of Contents Table of Contents Specifications Hardware Specifications Management Software Specifications SpecificationsOverview 2.1 Introduction FeaturesWhat’s Included Front and Back Panels 2.4.1 Front Panel OverviewBack Panel LED Indicators LED IndicatorsLED Installing an SFP fiber transceiver into the LPB724A switch Installing an Optional SFP Transceiver ModulePower On InstallationInstalling Switch to a 19-Inch Wiring Closet Rail Cabling RequirementsTypical Network Topology in Deployment Switch Cascading in TopologyVlan LPB708A/LPB716A Set IP Address, Subnet Mask, and Default Gateway IP AddressLogin screen for Web Operation of Web-based Management Password adminIP Address Assignment AdministratorWeb Management Home Overview System IP Configuration Authentication ConfigurationSystem Status System IP Configuration screenFirmware Update Load Default SettingReboot Device Port ManagementPort Mirroring Port Configuration10. Port Mirroring screen Bandwidth Control5 PoE Broadcast Storm ControlVlan Mode Vlan SettingPort-based VLAN- Vlan Member Tag-based Vlan 15. Port-based Vlan Member Setting screen16. Tag-based Vlan screen Tag-based VLAN-VLAN Member17. Tag-based Vlan Member Setting screen Multi to 2 SettingPer Port Counter Counter Category 18. Multi to 2 Setting screenClass of Service QoS Setting Priority Mode21. TCP/UDP Port configuration screen Class of Service- TCP/UDPClass of Service-802.1p Class of Service-IP TOS/DSMAC Address Configuration Class of Service-Physical PortSecurity 2 TCP/UDP Filter Configuration 26. TCP/UDP filtering configuration Spanning Tree STP Bridge Settings27. STP Bridge Settings screen STP Port SettingsTrunking 28. STP Port Settings screenIP Address Assignment Function name Backup/Recovery Backup/RecoveryLogout 32. Miscellaneous Setting screenTroubleshooting IP address IP Address AssignmentSubnet Mask Default Gateway DNS LPB708A, rev