Asus PCEN10 Configuring PCE-N10 using Asus utility, Connecting to a wireless network manually

Page 12

PCE-N10 WLAN Card User Manual

3. Configuring PCE-N10 using ASUS utility

3.1Connecting to a wireless network manually

To connect PCE-N10 to a station (Ad Hoc mode) manually:

1.Right-click the ASUS WLAN Card Setting Utility icon in the Windows® system tray, then select Wireless Setting.

2.You may click Survey > Search to search for the wireless networks. Select a network (AP from the available network list) and then click Connect.

3.If Security is enabled on the AP or station, do the same security settings on your WLAN card as those on the AP or station. Click Save.

Setup is completed. The Status page displays information such as the association state, current data rate, and radio state.

ASUS WLAN Card

Image 12

Contents PCE-N10 E6391 / FebruaryCopyright 2011 ASUSTeK Computer Inc. All Rights Reserved Manufacturer contact information ASUSTeK Computer Inc. Asia-PacificAsus Computer International America Technical supportTable of contents Federal Communications Commission Prohibition of Co-locationFCC Radiation Exposure Statement CE Mark Warning DGT Warning StatementIC Warning Statement ArticleAsus Recycling/Takeback Services IC Radiation Exposure StatementEC Declaration of Conformity Manufacturer ASUSTeK Computer Inc Asus Computer GmbHEurope Authorised distributorsPackage contents IntroductionSystem requirements HardwareInstalling the PCE-N10 driver and utilities Click Install to start the installationComplete the installation Configuring PCE-N10 using Asus utility Connecting to a wireless network manuallyConnecting to a wireless network using WPS Select Use the WPS button, then click NextSelect Use PIN code Soft AP mode Windows XP/Vista/7 Access Control List field ACLAsus Wlan Card Setting Utility Asus Wlan Card Setting Utility system tray iconSoftware information Asus Wlan Control CenterAsus Wlan Card Config Basic OthersConfig Encryption Config Advanced ManuallyConfiguring PCE-N10 using Windows WZC service Click Windows Wireless to use itTroubleshooting How do I verify that my Wlan card is installed properly?My Wlan card cannot connect to any Access Points Connection quality is bad and the signal strength is weakTCP/IP protocol does not bind to the Wlan Card Glossary Default Key Dhcp Dynamic Host Configuration ProtocolCofdm for 802.11a or 802.11g Device NameDNS Server Address Domain Name System DSL Modem Digital Subscriber LineDirect-Sequence Spread Spectrum for 802.11b Extended Service Set ESS Essid Extended Service Set IdentifierEncryption EthernetIeee Ieee 802.11a 54Mbits/secIeee 802.11b 11Mbits/sec Ieee 802.11gInfrastructure ISP Internet Service Provider MAC Address Media Access ControlIP Internet Protocol IP AddressNIC Network Interface Card PacketPass Phrase PPP Point-to-Point ProtocolSsid Service Set Identifier Weca Wireless Ethernet Compatibility AllianceRadio Frequency RF Terms GHz, MHz, Hz StationWPA Wi-Fi Protected Access Wlan Wireless Local Area NetworkRequirements