Service
6.Remove the entire counter assembly (31) (FIG. 30). 31
FIG. 30
Reassembly
1.Install counter assembly (31) (FIG. 31).
31
FIG. 31
2.Install the gears (32, 34). Use a 2 mm hex wrench to tighten gear set screw (33). (FIG. 32).
34
3332
FIG. 32
3.Install face plate panel (37) and large retaining clip (38) (FIG. 33).
38
37
FIG. 33
4.Install the needle pointer (41), springs (39) and pins (40) as shown in FIG. 34.
41
39/40
FIG. 34
5.Install small retaining ring (43) and cover (44) (FIG. 35).
44
43
FIG. 35
18 | 333492B |