GBC USP 13 manual Selecting Knife SET-UP, Claw

Page 5

SELECTING KNIFE SET-UP

36

248115

CLAW

Figure 1

.13

1.Turn power off.

2.Cycle the machine with the hand wheel until the claw reaches between 10 and 11 o’clock. (Figure 2)

3.Cam #115 sets when the separating knife will go into the stack. Adjust the cam so that the tip of the knife is about 1/8” (.13) from the trailing edge of the claw. (Figure 2)

4.Cam #36 sets when the selecting knife will lift. Adjust the cam to get a lift of about 1/8” (.13). (Figure 3)

5.The separating knife should now enter the stack, then raise, support the stack and the claw will then select the lift. (Figure 3)

6.To adjust the thickness of the lift, turn the T-knob

(#248, Figure 1) clockwise for thicker lifts and counterclockwise for thinner lifts.

Figure 2

.13

Figure 3

Figure 4

3

Image 5
Contents Universal Speed Punch Universal Speed Punch Operator Manual Table of ContentsUSP USP 13 Universal Speed Punch Operating Instructions Service And Equipment Maintenance Agreement Claw Selecting Knife SET-UPS47 Outer Belt SET-UP InstructionsTo be in Line Rear Jogger Side Front Stop PulleysTo be Line Quick Reference Instructions USP 13 Universal Speed PunchMaintenance Instructions General Rules for Grinding Punching Pins of Punching Tools They include Options & AccessoriesPage 016509000