GBC USP 13 manual Rear Jogger Side Front Stop Pulleys, To be in Line

Place a sheet of paper against pusher (#111) in its home position (rear). Install the three paper support straps (#127 & #83, Figure 10) 1” away from the edge of the paper. Straps must be on top of transfer belts.

Cycle the machine by hand until the pusher has pushed the paper to its furthest point. Install long small roller assembly (#170, Figure 10) so that the small pulley is top of paper.

Adjust pusher again to its home position. Place a sheet of paper against pusher. Adjust the punch cam (#43, Figure 8) so that when the machine is cycled by hand, the paper is about 1” away from the front stop as it just reaches it full up position (Figure 11). There must be an O-ring on the paper at all times. Wheel (#167) is set on the edges of the paper so that they turn even when the paper is being punched.

SUPPLY STACK GUIDE

Cycle the machine by hand until the claw (#103) is in the 5 o’clock position. Position the disks as shown in Figure 12. Disks should not be over-tightened to where they cannot be moved by hand. Turn hand wheel to retract the knife and load paper square to the corner stack guide (#46).

167

REAR

JOGGER

SIDE

JOGGER

FRONT STOP

PULLEYS

Figure 11

111

CLAW

83

	THESE SURFACES
127	TO BE IN LINE
	46

1.0

170

Figure 10

Figure 12

6