USP 13
SET-UP INSTRUCTIONS:
After the punching die is properly installed, position the back gauge rail (#108, Figure 7) slightly ahead of the punch die back gauge so that a piece of paper can slide freely into the throat of the die and not hit the back gauge of the punch die.
108
SETTING REGISTRATION
Loosen locking bolt (S40) under front bearing block (#93, Figure 9) prior to setting registration.
Position the front stop (#26) so it is in its full up position. Place a sample sheet of paper against the front stop and punch paper. If the punch pattern is not centered on the paper, adjust the front stop by turning
34
100
26
.25
OUTER BELT
248
the front stop adjustment rod (#117) until the punch pattern is centered. Once the front stop is set properly, adjust the rear jogger so that it touches the paper. To do this, turn the rear jogger stop adjustment (#118).
93
29
Figure 7
Cam (#37) activates the rear jogger (#34) and the side jogger (#29). Adjust the cam so that when the longest punch pin appears in the throat of the punching die, the rear jogger (#34) should have just reached the full vertical position.
Cam (#44) activates the front stop (#26). Adjust the cam so that when the front stop finger (#100) reaches the full vertical position, the side jogger (#29) starts its cycle inward.
43
37
44
Figure 8
118
117
Figure 9
When registration is set, lock in place by tightening locking bolt. (S40, Ref. Page 30).
CONVEYOR SYSTEM
Cycle this machine manually by turning the hand wheel until the rear jogger is in its full up position. Install side jogger (#29) to slightly buckle a sheet of paper. Lock in place with
Adjust the outer transfer belt (#255, Figure 7) so that it sets about 1/4” (.25) away from fully jogged side jogger.
5