Casio DT-X5 manual Safety Battery Pack

Page 48

6.2 Safety

6.2.1 Battery Pack

•Never disassemble or retrofit the battery pack. The battery pack has safety mechanism and protection means incorporated to avoid hazards. Should they be damaged, the battery pack could become hot, generate smoke, explode, or ignite.

•Never contact the “+” and “-“ terminals with metal objects such as a wire.Also, do not carry or store the battery with a metal necklace or hair pin. Otherwise, the battery pack may be short-circuited resulting in an excessive current and causing the battery to become hot, smoke, explode, or catch fire.

•Neither dispose of the battery pack into a fire nor heat it. The insulation may be burnt, the gas exhaust valve or safety mechanism may be damaged, or the internal electrolyte may ignite, causing the battery pack to become hot, smoke, explode, or ignite.

•Neither leave nor use the battery pack in a place with a high temperature (over 80 °C) or close to a fire or hot stove. Should the resin separator be damaged due to excessive heat, the battery pack may be short-circuited causing it to become heated, smoke, explode, or ignite.

•Do not soak the battery pack in fresh water or sea water. If the protection means incorporated in the battery pack is damaged, the battery pack may become hot, smoke, explode, or ignite.

•Do not attempt to charge the battery close to a fire, in direct sunlight, or in a car parked in the sun.Aheated battery pack will trigger the internal hazard protection means to stop the charging function. Or, the protection means may be damaged and the battery may be charged with an excessive current or voltage, or have abnormal chemical reactions induced to cause it to become hot, smoke, explode, or ignite.

•Do not stick a pin or nail in the battery pack. Neither hit it with a hammer nor stamp it. If this is done, the battery pack may be broken or deformed resulting in a short circuit and causing it to become hot, smoke, explode, or ignite.

•Do not hit or throw the battery pack. If the protection means incorporated in the battery pack is damaged, the battery pack may be charged with an excessive current or voltage, or have abnormal chemical reactions induced to cause it to become hot, smoke, explode, or ignite.

•Never use a battery pack that is significantly damaged or deformed. It may become hot, smoke, explosion, or ignite.

•Do not attempt to solder anything directly on the battery pack surface. The insulation may be damaged or the gas exhaust valve or safety mechanism may be damaged, causing the battery pack to become hot, smoke, explode, or ignite.

•Do not use the battery pack in other device than the DT-X5. The performance or service life of the battery pack may be reduced or abnormal current may flow to cause it to become hot, smoke, explode, or ignite.

•When charging the battery pack use only dedicated cradles or dedicated battery charger and itsAC adaptor available from CASIO, at a temperature between 0°C and 40°C. If the battery pack is charged with battery chargers other than those specified by CASIO, it may be over-charged, or charged with an excessive current, or have abnormal chemical reactions induced, causing it to become hot, smoke, explode, or ignite.

•The battery pack has a specific polarity. Do not force it into the DT-X5. Check the polarity. If the battery pack is connected backwards, it can be incorrectly charged and have an abnormal chemical reaction induced, causing it to become hot, smoke, explode, or ignite.

•If the internal electrolyte of the battery pack leaks and enters the eye, do not rub the eye. Rinse the eye with a sufficient amount of clean water, such as tap water, then immediately consult with a doctor. The electrolyte can cause eye damage.

48

Page 47 Page 49
Image 48
Page 47 Page 49
Contents DT-X5 Series Hardware Manual Table of Contents Precautions Handling Precautions Safety Battery Pack General Editorial Record Preface Overview Features Incorporates .NET technologyEnhanced communicating functions Superb reading capabilityAvailable Models and Options Page Options And Interfaces DT-X5General Guide Views for DT-X5M10E, DT-X5M10RFront view in .3 is for all the models of DT-X5 series Names of parts Description Indicator When a reading error has occurredSatellite Cradle Power contacts Cradle-type Battery ChargerHA-A34AT Battery Charger Car Mount Unit ViewHA-A61IO and HA-A60IO Cradles ViewsTop Right Back Front Desktop unit in the case of a wall mount configuration DIP switchesRequires installation of a special driver on the PC Installation of a special driver on the PC3 DT-5022CHG Dual Battery Charger IndicatorsCharge status Bottom Connection attachmentsHA-A20BAT and DT-5025LBAT Battery Packs Bottom Left Top Side Charge/Power supply terminalsLeftTop Side Hardware Specifications DT-X5 Specification RemarkContinue Lithium-ion battery pack Memory backupBattery Power with HA-A20BAT DT-5025LBAT is fully Is room temperatureLithium-ion battery Is at room temperatureOperating hours by model LaserDigit/5-digit addon Yes NS output YesCode49 Yes Yes Codablock FEAN8/13 Composite RSS CompositeTest chart Dedicated test pattern Reference for Laser Scanner PerformanceOr more 60 mm At contact 355 mm At 400 mm depthUnit mm Reference for C-MOS Imager Performance PCSTest chart Resolution 1D 0.25 mm / 2D 0.5 mmOr greater Read judgment Times per 10 scans First Decode DepthHA-A60IO, HA-A61IO USBWeight/Dimensions Dimensions Desktop state Approx W x 125 D x 128 H mmWeight Desktop state Approx g Approx W x 148 D x 153 H mmHA-A34AT OFFDimensions Configuration Wall-mount HA-A30CHGDIP Switch Setting for HA-A61IO Power Status Indications with LEDsPower Supply Block DT-5022CHGBasic Block Interface BlockBattery Charge Block HA-A20BAT, DT-5025LBAT Product Identification and Reference Numbers Box Temperature 20 ºC to 60 ºC Humidity 90 %RH or less Quality ReferencesEnvironmental Performances DT-X5 Box Temperature 10 ºC to 50 ºC Humidity 30% to 90%RH HA-A60IO, HA-A61IO, HA-A30CHGSplash proof Not applicable 4 DT-5022CHG Storage 10 to 55 ºC With carton box Humidity OperationElectrical Performances DT-X5 4 DT-5022CHG 3 DT-5022CHG CornersCm or less Master carton box Cm or lessCm or less Faces, 3 edges, 1 corner onto P-tile Reliability DT-X5 210,000 hours or moreProtection from short Charge terminalsEMC, EMI, Safety, Wlan /Bluetooth type approvals Compliance DT-X5AD-S42120AE, AD-S45150AU, AD-S45150AE Cable Specifications For Chain Connection and Short Length For Chain Connection and Long Length View from sidePrecautions Handling Precautions Precautions for short-term storage 1 to 2 daysPrecautions for long-term storage over one week Safety Battery Pack General Memory protection
Top Page Image Contents