AC Adaptor
Note the following important precautions when using an AC adaptor to power your Label Printer.
•Use only a genuine CASIO
•Be sure to turn the Label Printer off before you connect the adaptor. Do not turn power on until the adaptor is connected to the Label Printer and plugged into and AC outlet.
•Be sure to unplug the AC adaptor from the AC outlet whenever you are not using the Label Printer.
Turning Power On and Off
Press ON to turn power on, and OFF to turn power off.
Important!
•If you are using the Label Printer for the first time, you should reset it first.
Resetting the Memory
You should reset the memory of the Label Printer before using it for the first time, after you have not used it for a long time, or if nothing happens when you turn power on, even after you change the batteries.
Important!
AC Adaptor Cap
Remove the ADAPTOR CAP before connecting the AC adaptor.
Insert the adaptor cap into the ADAPTOR CAP holder located inside the back cover to avoid losing the cap.
To connect the AC adaptor
ADAPTOR CAP
ADAPTOR CAP holder
Inside back cover
•Resetting Label Printer memory clears its memory of all input data.
To reset the memory
1. | Make sure that Label Printer power is off. |
|
2. | While holding down the PRINT and ESC keys, | INT? |
| press ON to turn power on. | |
3. | the ON key only. | |
Keeping PRINT and ESC held down, release |
|
4.Press SET to initialize the Label Printer or ESC to abort the reset operation without initializing anything.
•See “Initializing the Label Printer” on page 18 for information on the initial default settings of the Label Printer following the reset operation.
Auto Power Off Function
Connect the adaptor to the Label Printer as shown in the illustration. Plug the other end into a stand- ard household AC outlet.
If you do not perform any key operation for about six minutes, the Label Printer automatically turns power off. To restore power, press ON.
Tape Cartridges
Use the procedures described below to load a tape cartridge into the Label Printer. After you load the tape cartridge, be sure to use the procedure de- scribed under “Tape Width Specification” on page 8 to tell the Label Printer what is the width of the tape you are using.