Samsung STP-102P, STP-102S instruction manual Functions, Commands, 2122

Chapter 7. Functions

The commands listed in the table below are available for control of the printer.

Commands

	Command Classification		Standard
Command	Name
		Setting	Mode
	Executing
HT	Horizontal tab
LF	Print and line feed
ESC SP	Set right-side character spacing
ESC !	Select print mode(s)
ESC $	Set absolute print position
ESC %	Select/cancel user-defined character set

ESC & Define user-defined characters

ESC * Select bit-image mode

ESC - Turn under line mode on/off

ESC 2 Select 1/6-inch line spacing

ESC 3 Set line spacing

ESC ? Cancel user-defined characters

ESC @ Initialize printer

ESC D Set horizontal tab positions

ESC E Turn emphasized mode on/off

ESC J Print and feed paper

ESC R Select an international character set

ESC S Select standard mode

ESC V Turn 90 clockwise rotation mode on/off

Command	Command Classification		Standard
	Name
		Setting	Mode
	Executing
ESC \	Set relative print position
ESC a	Select justification
ESC c5	Enable/disable panel buttons
ESC d	Print and feed paper n lines
ESC {	Turn upside-down printing mode on/off
GS $	Select haracter size
GS /	Define downloaded bit image
GS :	Start/end macro definition
GS B	Turn white/black reverse printing mode on/off
GS L	Set left margin		(	)
GS P	Set vertical and horizontal motion units
GS W	Set printing area width		(	)
GS ^	Execute macro
GS h	Set bar code height
GS k	print bar code
GS w	Set bar code width

Command classification

Executing : Printer executes the command, which does not affect the following data.

Setting : Printer uses flags to make setting, and those setting affect the following data.

Standard mode

: Enagled

( ) : Enabled only when the command is used at the beginning of a line. : Enabled only when data is not present in the buffer.

2122