Samsung STP-102S, STP-102P Connecting the Cable, Connecting the AC adapter to your printer

Page 4
Chapter 2. Connecting the Cable

Chapter 2. Connecting the Cable

2-1. Connecting the AC adapter to your printer

When the printer is used, use te optional AC adapter, AP-1611-UV for your printer.

￿￿￿￿￿￿￿

Using an incorrect power supply may cause fire or electrical.

￿￿￿￿￿￿￿

When connecting or disconnecting the power supply from the printer, make sure that the power supply is not plugged into an electrical outlet ; otherwise you may damage the power supply or the printer

1.Make sure that the printer's power switch is turned off, and that the power supply's power cord is unplugged from the electrical outlet.

2.Check the label on the power supply to make sure that the requird voltage matches that of your electrical outlet.

3.Plug the power supply's DC cable connector into the printer's power connector as shown below.

STP-102S / STP-102P

4. Plug the AC adapter's power cord into an electrical outlet.

NOTE

To remove the DC cable connector grasp the connector at the arrow and pull it straight out. Make sure that the main unit's power cord is unplugged before you disconnect the DC cable connector.

2-2. Connecting the printer to your Computer

STP-102S

You need an appropriate serial interface cable to connect your computer to the printer's built-in interface.

1.Make sure that both the printer and computer are turned off :

then plug the cable connector securely into the printer's interface connector.

2.Tighten the screws on both sides of the cable connector.

25 Pin Male Type

3. Plug the other end of the cable into the computer

78

Image 4
Contents Warning - U.S Notice - CanadaIntroduction STP-102S / STP-102PTable of Contents Chapter 1. UnpackingPower cord Roll paperIndicator lights POWERgreenERRORred 1-3. Printer Part NamesChapter 2. Connecting the Cable 2-1. Connecting the AC adapter to your printer2-2. Connecting the printer to your Computer STP-102SThe printer must be turned off before installing the paper roll Chapter 3. Installing the Paper RollSTP-102P Chapter 4. Setting the DIP Switches DIP switch functionsChapter 5. Running the Self-test Chapter 6. Code TablePC850 Multilingual 1516PC860 Portuguese PC863 Canadian - French 1718PC865 Nordic 1920 Space PageChapter 7. Functions Commands2122 Chapter 8. Control Commands Command NotationControl Commands HT Explanation of TermsESC * m nL nH d1...dk ESC - nESC 3 n ESC @ESC J n ESC R nESC V n ESC \ nL nHESC c 5 n ESC d nGS ! n ESC nGS B n GS L nL nHGS W nL nH GS r t mAPPENDIX A CONNECTORS GS h n1 GS k m d1... dk NUL 2 GS k m n d1... dnJF01-000012 APPENDIX B Specification7.5V 2.2A