LED is blinking but no images on the screen.
Is the frequency properly adjusted when checking the Display Timing on the menu?
Adjust the frequency properly by referring to the video card manual and Preset Timing Modes.
(The maximum frequency per resolution may differ from product to product.)
There are only 16 | Have the Windows colors |
colors shown on the | been set properly? |
screen. |
|
The screen colors |
|
have changed after | Has the video card been set |
changing the video | |
card. | properly? |
I cannot use the | Does the graphics card on |
2560x1600 resolution | your computer support the |
with the monitor. | 2560x1600 resolution? |
Windows ME/2000/XP :
Set the colors properly at the
Control Panel → Display →
Settings.
Set the video card by referring to the video card manual.
If your graphics card does not support the 2560x1600 resolution, then you can only use the 1280x800 resolution with your monitor.
To use the 2560x1600 resolution, replace your graphics card with one that supports that resolution.
Check the following items if there is trouble with the monitor.
1.Check if the power cord and the video cables are properly connected to the computer.
2.Check if the computer beeps more than 3 times when booting.
(If it does, ask the service center to check the main board of the computer.)
3.If you installed a new video card or if you assembled the PC, check if the installed the adapter (video) driver.
4.Check if the scanning ratio of the video screen is set at 60 Hz +/- 2 Hz. (Do not exceed 60 Hz when using the maximum resolution.)
5.If you have problems in installing the adapter (video) driver, boot the computer in Safe Mode, remove the Display Adapter at the "Control Panel→System→Device Administrator" and then reboot the computer to reinstall the adapter (video) driver.
If problems repeatedly occur, contact an authorized Service Center.
Q & A
Question
How can I change the frequency?
Answer
The frequency can be changed by reconfiguring the video card.
Note that video card support can vary, depending on the version of the driver used. (Refer to the computer or the video card manual for details.)
How can I adjust the resolution?
How can I set the Power Saving function?
How can I clean the outer case/LCD Panel?
Windows ME/XP/2000 : Set the resolution at the Control Panel→Display→Settings.
* Contact the video card manufacturer for details.
Windows ME/XP/2000 : Set the function at
Disconnect the power cord and then clean the monitor with a soft cloth, using either a cleaning solution or plain water.
Do not leave any detergent or scratches on the case. Do not let any water enter the monitor.