Samsung XL30 manual Attaching a Base

Page 19

1.Turn off your monitor and unplug its power cord.

2.Lay the LCD monitor face-down on a flat surface with a cushion beneath it to protect the screen.

3.Remove four screws () and then remove the Stand from the LCD monitor.

Attaching a Base

This monitor accepts a 200 mm x 100 mm VESA-compliant mounting interface pad.

Monitor

Mounting interface pad (Sold separately)

1.Turn off your monitor and unplug its power cord.

2.Lay the LCD monitor face-down on a flat surface with a cushion beneath it to protect the screen.

3.Remove four screws and then remove the stand from the LCD monitor.

4.Align the mounting interface pad with the holes in the rear cover mounting pad and secure it with four screws that came with the arm-type base, wall mount hanger or other base.

zDo not use screws longer than the standard dimension, as they may damage the inside of the Monitor.

zFor wall mounts that do not comply with VESA standard screw specifications, the length of the screws may differ depending on their specifications.

zDo not use screws that do not comply with the VESA standard screw specifications. Do not fasten the screws too tightly, as this may damage the product or cause the product to fall, leading to personal injury.

Samsung is not liable for these kinds of accidents.

zSamsung is not liable for product damage or personal injury when a non-VESA or non- specified wall mount is used or the consumer fails to follow the product installation instructions.

zTo mount the monitor on a wall, you should purchase the wall mounting kit that allows you to mount the monitor at least 10cm away from the wall surface.

zContact the nearest Samsung Service Center for more information. Samsung Electronics will not be responsible for damages caused by using a base other than those specified.

zPlease use Wall Mount according to the International standards.

Installation Using the Hood

What is the Hood?

It is a device that can be attached to the top, right and left of the monitor to screen sunlight, preventing any color distortion. You can change the colors of the entire screen according to your preferences.

Image 19
Contents SyncMaster XL30 Notational PowerUse only a properly grounded plug and receptacle Insert the power plug firmly so that it does not come looseDo not disconnect the power cord while using the monitor Do not use a damaged or loose plugDo not drop the monitor when moving it InstallationDo not place the product on the floor Do not place the monitor face down CleanKeep any heating devices away from the power cable Put down the monitor carefullyDo not spray water or detergent directly onto the monitor OthersDo not remove the cover or back Do not cover the vents on the monitor cabinet Do not install inside a vehicleNever insert anything metallic into the monitor openings Page Good Postures When Using the Monitor Monitor Driver UnpackingCable Hood FrontMode button = Color Mode Rear Adjust buttonsScreen is getting dark Kensington Lock Stand StopperDown USB downstream port Connect the Down DVI-D Connecting the MonitorConnecting the Monitor Connecting USBUSB port of the monitor supports High-Speed Certified USB Sliding Changing the Stand and Installing the HoodsSwivel Removing the base Tilt angleAttaching a Base Page Check List SymptomSolutions Check ListQuestion Control Panel → Display → SettingsAnswer Signal Cable ResolutionInput Signal, Terminated Power SupplyVesa Mounting Interface Power offNormal Power saving Power button59.972 268.5 Horizontal Frequency Preset Timing ModesHorizontal 59.91 VESA, 2560 xEurope Contact Samsung WorldwideNorth America Latin AmericaAsia Pacific CISTerms Middle East & AfricaFor Better Display AuthorityDisclaimer Wording for Adobe Software Products Europe Final Version 12TH September Suggestions for specific applications WarrantyWhat is Image retention ? Power Off, Screen Saver, or Power Save Mode
Related manuals
Manual 16 pages 62.1 Kb