Samsung 913V manual Monitor Assembly

Page 12

1.Connect the power cord for your monitor to the power port on the back of the monitor. Plug the power cord for the monitor into a nearby outlet.

2-1.Using the D-sub (Analog) connector on the video card.

Connect the signal cable to the 15-pin, D-sub connector on the back of your monitor.

2-2.Connected to a Macintosh.

Connect the monitor to the Macintosh computer using the D-SUB connection cable.

2-3.In the case of an old model Macintosh, you need to connect the monitor using a special Mac adapter.

3.Turn on your computer and monitor. If your monitor displays an image, installation is complete.

Monitor Assembly

Image 12

Contents SyncMaster Power Do not use a damaged or loose plugInstallation Insert the power plug firmly so that it does not come looseDo not drop the monitor when moving it Use only a properly grounded plug and receptacleKeep any heating devices away from the power cable Do not place the product on the floorSet down the monitor carefully Do not place the monitor face downClean Do not spray water or detergent directly on the monitorOthers Do not remove cover or backDo not cover the vents on the monitor cabinet Never insert anything metallic into the monitor openingsFalling product could cause physical damage even death Unpacking Front Rear Sub 15-pin portMonitor Assembly Attaching a base Windows XP/2000 Click Windows XP/2000 DriverMicrosoft Windows XP Operating System Page Page How to install Click Start , Setting , Control Panel Microsoft Windows NT Operating SystemLinux Operating System How to install the Natural Color software Natural ColorNatural Color Software Program Auto MagicBright MenuDescription Adjust Brightness BrightnessPicture Color ImageDescription Play/Stop Color Tone Color Control GammaOSD Coarse Fine Sharpness PositionSetup InformationLanguage Position Transparency Display Time Shows a video source, display mode on the OSD screen What is MagicTune? OSD ModeBasic Functionality Installation Page Installationation Problems Hardware Button Tab Definition Picture Tab DefinitionColor Tab Definition BrightnessImage Tab Definition Color ToneImage Setup Option Tab DefinitionSupport Tab Definition PreferencesColor Calibration PreviewPage Uninstall Troubleshooting Symptom Can you see Check Signal Cable on the screen?Mode,Recommanded Mode 1280 x 1024 60Hz on the screen? SolutionsRefer to the Preset Timing Modes Panel → Display → SettingsSelf-Test Feature Check Useful Tips General PowerSaver Preset Timing ModesHorizontal Frequency Vertical FrequencyService Australia BrazilGermany Portugal United KingdomTerms For Better DisplayAuthority FCC Information User Instructions User InformationIC Compliance Notice Why do we have environmentally-labelled monitors? MPR II ComplianceEuropean NoticeEurope Only PCT NoticeWhat does labelling involve? Environmental RequirementsLead CadmiumWhy do we have environmentally labelled computers? CFCs freonsTCO Development Environmental requirements Flame retardants ErgonomicsEnergy EmissionsEcology TCO03 Recycling Information TCO03 applied model onlyVideo In / RS 232 / Video Out Transport and Storage LimitationsWhat is Image retention ? Power Off, Screen Saver, or Power Save ModeSuggestions for specific applications