Samsung 913V manual Attaching a base

Page 13

1.Monitor and Bottom

2.Monitor and Hanger

Attaching a base

This monitor accepts a 100 mm x 100 mm VESA-compliant mounting interface pad.

	A.Monitor
	B.Mounting interface pad
1.	Turn off your monitor and unplug its power cord.
2.	Lay the LCD monitor face-down on a flat surface with a cushion beneath it to protect the screen.
3.	Remove four screwsand then remove the Stand from the LCD monitor.
4.	Align the Mounting Interface Pad with the holes in the Rear Cover Mounting Pad and secure it with four
	screws that came with the arm-type base, wall mount hanger or other base.

When prompted by the operating system for the monitor driver, insert the CD-ROM included with this monitor. Driver installation is slightly different from one operating system to another. Follow the directions appropriate for the operating system you have.

Prepare a blank disk and download the driver program file at the Internet web site shown here.

zInternet web site : http://www.samsung.com/ (Worldwide) http://www.samsung.com/monitor (U.S.A) http://www.sec.co.kr/monitor (Korea)

Image 13

Contents SyncMaster Do not use a damaged or loose plug PowerInsert the power plug firmly so that it does not come loose InstallationDo not drop the monitor when moving it Use only a properly grounded plug and receptacleDo not place the product on the floor Keep any heating devices away from the power cableSet down the monitor carefully Do not place the monitor face downDo not spray water or detergent directly on the monitor CleanDo not remove cover or back OthersNever insert anything metallic into the monitor openings Do not cover the vents on the monitor cabinetFalling product could cause physical damage even death Unpacking Front Sub 15-pin port RearMonitor Assembly Attaching a base Click Windows XP/2000 Driver Windows XP/2000Microsoft Windows XP Operating System Page Page Microsoft Windows NT Operating System How to install Click Start , Setting , Control PanelLinux Operating System Natural Color How to install the Natural Color softwareNatural Color Software Program Auto Menu MagicBrightDescription Brightness Adjust BrightnessPicture Image ColorDescription Play/Stop Color Tone Color Control GammaCoarse Fine Sharpness Position OSDInformation SetupLanguage Position Transparency Display Time Shows a video source, display mode on the OSD screen OSD Mode What is MagicTune?Basic Functionality Installation Page Installationation Problems Hardware Picture Tab Definition Button Tab DefinitionBrightness Color Tab DefinitionColor Tone Image Tab DefinitionOption Tab Definition Image SetupPreferences Support Tab DefinitionPreview Color CalibrationPage Uninstall Troubleshooting Can you see Check Signal Cable on the screen? SymptomMode,Recommanded Mode 1280 x 1024 60Hz on the screen? SolutionsPanel → Display → Settings Refer to the Preset Timing ModesSelf-Test Feature Check Useful Tips General Preset Timing Modes PowerSaverVertical Frequency Horizontal FrequencyAustralia Brazil ServiceGermany United Kingdom PortugalFor Better Display TermsAuthority User Information FCC Information User InstructionsIC Compliance Notice MPR II Compliance Why do we have environmentally-labelled monitors?European NoticeEurope Only PCT NoticeEnvironmental Requirements What does labelling involve?Lead CadmiumCFCs freons Why do we have environmentally labelled computers?TCO Development Ergonomics Environmental requirements Flame retardantsEmissions EnergyEcology TCO03 Recycling Information TCO03 applied model onlyTransport and Storage Limitations Video In / RS 232 / Video OutPower Off, Screen Saver, or Power Save Mode What is Image retention ?Suggestions for specific applications