Samsung 795MB+ manual PowerSaver, Preset Timing Modes

90 ~ 264VAC rms, 60/50 Hz ± 3Hz

Power Consumption

Less than 75W

Dimensions (WxDxH)

402 x 412 x 402 mm / 15.8 x 16.2 x 15.8 inch (After installation of Stand)

Weight

14.65kg

Environmental considerations

Operating	Temperature 32°F ~ 104°F(0°C ~ 40°C)
	Humidity 10% ~ 80%, non-condensing
Storage	Temperature -4°F ~113°F (-20°C ~ 45°C)
	Humidity 5% ~ 95%, non-condensing

Plug and Play Capability

This monitor can be installed on any Plug & Play compatible system. Interaction of the monitor and computer systems will provide the best operating conditions and monitor settings. In most cases, monitor installation will proceed automatically, unless the user wishes to select alternate settings.

Note: Design and specifications are subject to change without prior notice.

PowerSaver

This monitor has a built-in power management system called PowerSaver. This system saves energy by switching your monitor into a low-power mode when it has not been used for a certain amount of time. The monitor automatically returns to normal operation when you press a key on the keyboard. For energy conservation, turn your monitor OFF when it is not needed, or when leaving it unattended for long periods. The PowerSaver system operates with a VESA DPMS compliant video card installed in your computer. Use a software utility installed on your computer to set up this feature.

State	Normal Operation	Power-off mode
		EPA/ENERGY 2000
Power Indicator	Green	Green, Blinking
Power Consumption	Less than 75W	Less than 2W

Preset Timing Modes

If the signal transferred from the computer is the same as the following Preset Timing Modes, the screen will be adjusted automatically. However, if the signal differs, the screen may go blank while the power LED is on. Refer to the video card manual and adjust the screen as follows.

	Horizontal	Vertical	Pixel Clock	Sync Polarity
Display Mode	Frequency	Frequency
			(MHz)	(H/V)
	(kHz)	(Hz)
VESA, 640 x 480	37.500	75.000	31.500	-/-