Samsung 760TFT manual Check List

Check List

Q & A

Self-Test Feature

Check

The screen is out of focus or OSD cannot be adjusted.

LED is blinking but no images on the screen.

There are only 16 colors shown on the screen. The screen colors have changed after changing the video card.

Have you adjusted the resolution or frequency on the monitor?

Is the frequency properly adjusted when checking the Display Timing on the menu?

Have the Windows colors been set properly?

Has the video card been set properly?

Adjust the resolution and frequency of the video card.

(Refer to the Preset Display Modes).

Adjust the frequency properly by referring to the video card manual and the Preset Display Modes.

(The maximum frequency per resolution may differ from product to product.)

For Windows 95/98/ME/XP/2000: Set the colors properly at the Control Panel, Display, Settings.

For Windows 3.1:

Adjust the colors of the screen using the VGA utility provided by the video card.

Set the video card by referring to the video card manual.

There is a message that reads "Unrecognized monitor, Plug & Play (VESA DDC) monitor found".

Have you installed the monitor driver?

See the video card manual to see if the Plug & Play (VESA DDC) function can be supported.

Install the monitor driver according to the Driver Installation Instructions.

Install the monitor driver according to the Driver Installation Instructions.

Check the following items if there is trouble with the monitor.

1.Check if the power cord and the cable are properly connected to the computer.

2.Check if the computer beeps more than 3 times when booting.

(If it does, request an after-service for the main board of the computer.)

3.If you installed a new video card or if you assembled the PC, check if the installed the adapter (video) driver and the monitor driver.

4.Check if the scanning ratio of the video screen is set at 75Hz or 85Hz. (Do not exceed 60Hz when using the maximum resolution.)

5.If you have problems in installing the adapter (video) driver, boot the computer in Safe Mode, remove the Display Adapter at the "Control Panel, System, Device Administrator" and then reboot the computer to reinstall the adapter (video) driver.

Note: If problems repeatedly occur, contact an authorized service center.