up to four displays at a time. Although it may operate between 4 to 6 displays simultaneously, but Samsung Electronics cannot guarantee normal operation in that case.
2.The display you wish to control does not appear on the other Control Info Grids
-Check to see if the display power is ON. (You can check this in Power Control Info Grid)
-Check if you can change the input source of the display.
3.The dialogue box (Figure
-Check to see if the display you wish to control is selected.
4.Both On Timer and Off Timer have been set but different time is showing.
-Apply current time to synchronize the display 
clocks.
5.The remote may not function properly when you turn off the remote Function, disconnect the
6.<Note> This program may malfunction due to problems in communication circuits or interference from electronic appliances nearby.
7.Go to (Samsung Electronics Web Site) or contact Samsung Electronics personnel at (phone numbers, contact info, service centers, etc.) (additional info necessary)
10. Settings Value Display In Multiple Display Mode
When there are more than one displays connected, the settings values are displayed as follows.
1.No selection: Displays the Factory Default Value.
2.Selected one display: Fetches and displays the settings value for the selected display.
3.Selected one display (ID1) and add another display (ID3): The program, which was displaying the settings value of ID 1, fetches and displays the value of ID3.
4.Selected all sets using Select All: Returns to the Factory Default Value.
5.Maximum set connection of MDC Program is 6.