Samsung 400T Other, Do not place any heavy objects on the monitor, Keep all power adaptors apart

Page 7

Notational

Power

Installation

Cleaning

Other

English > Main > Safety Instructions > Ohter

Do not remove cover(or back). No user serviceable parts inside.

zThis may cause an electric shock or a fire.

zRefer servicing to qualified service personnel.

If your monitor does not operate normally - in particular, if there are any unusual sounds or smells coming from it - unplug it immediately and contact an authorized dealer or service.

zThis may cause an electric shock or fire.

Do not place any heavy objects on the monitor.

zThis may cause an electric shock or a fire.

For each hour of looking at the monitor, you should let your eyes rest for 5 minutes.

zThis will reduce eye fatigue.

Do not use or store inflammable substances near the monitor.

zThis may cause an explosion or fire.

Do not try to move the monitor by pulling on the wire or the signal cable.

zThis may cause a breakdown, electric shock or a fire due to damage to the cable.

Do not move the monitor right or left by pulling only the wire or the signal cable.

zThis may cause a breakdown, electric shock or a fire due to damage to the cable.

Never insert anything metallic into the monitor openings.

zThis may cause an electric shock, fire or injury.

Keep all power adaptors apart.

Image 7
Contents SyncMaster 400T English Main Index Notational Do not use a damaged or loose plug PowerUse only a properly grounded plug and receptacle Set down the monitor carefully Do not drop the monitor when moving itDo not cover the vents on the monitor cabinet Place the monitor on a flat and stable surfaceCleaning Do not use or store inflammable substances near the monitor Keep all power adaptors apartOther Do not place any heavy objects on the monitorRemove and discard vinyl bag from power adaptor before use Keep power adaptor away from any other heat sourceAlways keep power adaptor in well-ventilated area Unpacking Front Rear Remote Control Mechanical Lay-outSource button FrontRear Remote Control Mechanical Lay-outButton Names Remote ControlReplacing Batteries Page Mechanical Lay-out Monitor Head Rear SpeakerSpeaker Mounting Bracket Connecting to a VCR Connecting to a ComputerConnecting Your Monitor Connecting a Camcorder Connecting to a DVD PlayerConnecting Speakers Connecting D-TV Set Top BoxConnecting to an Audio System and Sub-woofer Introduction InstallMultiple Display Control MDC Page Beginning Main Screen Beginning Port SettingBeginning Port Change Power ControlInput Source Control Aspect Ratio Control Video / S-Video / DVD Aspect Ratio Control PC Analog / PC Digital Aspect Ratio Control DTVTime Control Settings Control PictureRGB Settings Control PictureSettings Control Audio Troubleshooting Settings Control Image Lock PC Analog OnlySettings Value Display In Multiple Display Mode Monitor Buttons Remote Control ButtonsPower indicator Up / Down Key Move button Volume button / Select buttonExit button Press the menu to exit Menu button Caption button Press to set caption on/off Location button VCR-ControlsStill Volume PC Analog Screen Video / S-Video Screen PC Digital ScreenDVD / DTV Screen Fine tune For Better Display Self-Test Feature CheckVideo mode not supported Check before calling for service Problems and SolutionsDot Acceptable Maintenance and CleaningProblems related to Screen Problems related to InstallationProblems related to Remote Control Problems related to AudioQuestion Answer General PowerSaver Preset Timing ModesAudio Characteristics EPA/ENERGY PowerSaverVertical Frequency Preset Timing ModesPreset Timing Modes Horizontal FrequencyBrazil Service CenterUnited Kingdom EspañaNETHERLANDS/BELGIUM/LUXEMBOURG Dot Pitch Sync SignalTypes of Sync Signals ResolutionIC Compliance Notice RegulatoryFCC Information User Instructions User InformationPCT Notice European Notice Europe onlyNatural Color How to install the Natural Color softwareHow to delete the Natural Color software program Natural Color Software ProgramAuthority