Samsung 204T manual Connecting the Monitor

Page 14

Connecting the Monitor

1.Connect the power cord for your monitor to the power port on the back of the monitor. Plug the power cord for the monitor into a nearby outlet.

2-1.Using the D-sub (Analog) connector on the video card.

Connect the signal cable to the 15-pin, D-sub connector on the back of your monitor.

2-2.Using the DVI (Digital) connector on the video card.

Connect the DVI cable to the DVI port on the back of your monitor.

2-3.Connected to a Macintosh.

Connect the monitor to the Macintosh computer using the D-SUB connection cable.

2-4.In the case of an old model Macintosh, you need to connect the monitor using a special Mac adapter.

3.Turn on your computer and monitor. If your monitor displays an image, installation is complete.

Image 14
Contents SyncMaster 204T Notational Use only a properly grounded plug and receptacle Insert the power plug firmly so that it does not come looseDo not use a damaged or loose plug Do not place the product on the floor Do not drop the monitor when moving itKeep any heating devices away from the power cable Set down the monitor carefullyDo not place the monitor face down Do not spray water or detergent directly on the monitorDo not remove cover or back Do not cover the vents on the monitor cabinet Never insert anything metallic into the monitor openingsFalling product could cause physical damage even death Users Guide, Monitor Driver Quick Setup Guide Natural Color, MagicTuneMonitor Manual MagicRotation softwareSub Cable Power Cord Sold separately DVI Cable Set-Bracket Menu button Brightness button Enter button / Source buttonMagicBright button Power buttonAuto button CustomPage Stand Height Adjustment Connecting the Monitor Using the Stand Removing the base Attaching a BaseWindows XP/2000 Windows MEClick Windows ME Driver Click Windows XP/2000 DriverInstalling the Monitor Driver Manual Microsoft Windows XP Operating SystemPage How to install Linux Operating System Click Start , Setting , Control PanelMicrosoft Windows NT Operating System How to install the Natural Color software Natural Color Natural Color Software ProgramAuto Auto OSD Lock & Unlock Locked unlockedSource Brightness Contrast DescriptionPlay/StopGamma Coarse Fine Sharpness PositionLanguage Position Transparency Display Time Auto Source Image Reset Color Reset Page Overview Installation Page Installationation Problems Hardware Applies any changes made and exits MagicTune To execute Magic Pivot, it should be done as belowTray menu Contrast ResolutionBrightness MagicBrightColor Tone ControlMagicColor GammaSharpness Image SetupPosition Asset ID PreferencesSource Select Page How multiple users can use adjusted color values Color CalibrationPage Uninstall Troubleshooting Overview Installation Page Installationation Problems System Requirements Interface Page Page Uninstall Troubleshooting When connecting D-Sub cable When connecting DVI cabelThere is no image on the screen Settings Control Panel → Display →Question Useful Tips General Preset Timing Modes Environmental considerationsDisplay Mode Frequency Pixel Clock Sync Polarity KHz MHz Chile Sonda S.A Germany Panama United KingdomVertical Frequency ResolutionDot Pitch Horizontal FrequencyAuthority Suggestions for specific applications What is Image retention ?Power Off, Screen Saver, or Power Save Mode